Replacement Tack Room Door Latch for CM Dakota Horse Trailer

Question

Question:

I’m needing a replacement door latch for the tack door of my CM Dakota horse trailer. Is there any recommendations you may have?

asked by: Carlee

0

Expert Reply:

It would appear that your CM Dakota horse trailer uses a door latch like the Locking Steel Flush Door Latch with Inside Release # L1930. I have included an image with the measurements for this latch. Please let me know if your latch is different than these measurements.

expert reply by: Bud M

0

Measurements of Locking Steel Flush Door Latch with Inside Release # L1930
(click to enlarge)

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

On the inboard side of the Timbren Silent Ride Suspension #TSR7000T05 there are two flanges that have two slotted bolt holes on them. That is where the crossmember attaches. Each axle would be rated for 7k so with this you would have 14k of axle…

view full answer...

Answer 3

To run a charge line to your battery you will first need to install a 7-Way on your trailer. This can be done using the Epicord 7-Way Molded Trailer Plug with Junction Box #277-000141. The Black wire in the junction box is the one that will carry the…

view full answer...

Answer 4

Yes we can get over or under slung axles. It would be very similar to the Dexter Idler Trailer Axle w/ Hubs - EZ-Lube - 5 on 4-1/2 Bolt Pattern - 60" Long - 2,200 lbs part #20545I-EZ-60-10 but you would have them custom make it with the spring…

view full answer...

Answer 5

While we do not have the ability to pull part numbers from OEM build sheets, from images online it appears similar to #PLR5115. The measurement on this option is 5-1/2" by 4-1/4" requires a cutout of approximately 4-5/8" by…

view full answer...

Answer 6

As you have come to find out, the paddle style handle you have on your Wells Cargo Trailer is very large and they just don't make anything that large to replace this nowadays. The largest paddle style handle we have is the Paddle Handle Locking…

view full answer...

Answer 7

The Replacement Converter Section for Progressive Dynamics 4000 Series RV Power Control Center part #PD4045CSV is a direct replacement for the converter section on the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger part…

view full answer...

Answer 8

The Toyota 6 lug bolt pattern is the same 6 bolt pattern that trailers use of 6 on 5.5 inch so what you wanting to accomplish with a Timbren Axle Less setup is possible. The part #ASR3500S06 is the best option as it has a 4 inch lift built into it.…

view full answer...

Replacement Tack Room Door Latch for CM Dakota Horse Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching