Is Rubber on Base of Replacement Gutter Foot for Thule Gutter Feet # 753-0687 Dipped

Question

Question:

Hello, please confirm these foots are the version that have the base dipped in silicon rubber, and not the older version that uses the separate rubber sleeves that slide over the base. Thanks

asked by: Reed T

1

Helpful Expert Reply:

Yes the Replacement Gutter Foot for Thule Gutter Feet # 753-0687 that you referenced does have the rubber on the bottom of it that was dipped and not a rubber sleeve.

expert reply by: Jameson C

1

Answer 1

The Inno Feet for Square Crossbars are offered in a few different heights, 5.5" part #IN72FR, 7.5" part #INSD, and 9-7/8" part #INMDK. In order to see which is the best option for a 2019 Jeep Wrangler Unlimited with Sky Roof,…

view full answer...

Answer 2

It looks like you are trying to fit a Thule foot for a naked roof vehicle to your Jeep Wrangler which the bracket you mentioned is not designed to fit with. Instead you would need to replace the feet altogether like with the Rapid Gutter Feet part…

view full answer...

Answer 3

The Replacement Gutter Foot for Thule Gutter Feet #753-0687 is not one of the high towers. Although Thule was unable to provide me with exact measurements, I can tell you these have a 5" clearance above the rain gutters.

view full answer...

Answer 4

The Inno Feet for Square Crossbars part #INSD are designed for Inno Square Crossbars like part #INB127. That said, they both measure 7/8" x 1-1/4" so they should be interchangeable.

view full answer...

Answer 5

Yes. Since the Inno Square Crossbars #INB147 have the same dimensions as the Thule SquareBar Evo Crossbars #TH712300 (7/8" tall x 1-1/4" wide), the Inno Square Crossbars will fit the Replacement Railing Foot for Thule Tracker II 753-2152..

view full answer...

Answer 6

I have an answer for you. From the looks of your photo, it looks like it is the Rapid Gutter Feet for Thule Crossbars - Rain Gutters TH300R. However, even though the knobs on the Rapid Gutter Feet involve a space for Thule Same-Key Lock Cores…

view full answer...

Answer 7

It appears that you're referring to the Thule Rapid Gutter Feet #TH300R, which mount in the rain gutters of vehicles that don't have side rails or fixed mounting points. You would be able to mount these in any vehicle that has a built in rain…

view full answer...

Answer 8

Sounds like you are looking for the Replacement Mounting Hardware Kit #TAHD-80931 which is the install hardware kit for the TracRac ladder rack that the #TA01-11155 fits.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...