2020 Dodge Durango GT OEM Cladding Skirt Running Board Fitment

Question

Question:

Does a DeeZee NXc DZ16201-16241 running board fit my 2020 Durango GT with OE cladding skirt?

asked by: Miriam

0

Expert Reply:

I have some running boards that will fit, but the DeeZee NXc Running Boards w Custom Installation Kit # DZ16201-16241 aren't compatible with the OEM cladding skirt on your 2020 Dodge Durango GT.

Instead you need the Aries RidgeStep Running Boards # AA46FR which sit lower and further out so they will work - I confirmed this with my contact at Aries. These aren't the exact same ad the NXc but they do have the same general design.

expert reply by: Jon G

0

Answer 1

It's a plastic cladding that runs along the bottom of the door threshold area basically. If there was a plastic section that ran the distance between the wheel wells below the doors that would be the skirt cladding. There normally is a…

view full answer...

Answer 2

The most hidden trailer hitch available for your 2020 Dodge Durango is without a doubt the Draw-Tite Max-Frame Trailer Hitch Receiver #DT38MR. The 2" receiver for this Class III hitch will actually extend out through the bottom of the rear…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Yes, the DeeZee NXc Running Boards w Custom Installation Kit #DZ16201-16241 that you referenced are a confirmed fit for your 2018 Dodge Durango GT and will work great.

view full answer...

Answer 5

As long as your 2020 Jeep Grand Cherokee doesn't have the extra applied rocker panel molding or cladding under the doors, we have several running board and step bar kits from DeeZee and Aries Automotive that would fit your vehicle. Each kit…

view full answer...

Answer 6

There is a couple of way to determine which wheel bearings and grease seals you will be needed for a trailer axle. First, checking the numbers on the wheel bearings and seal will allow you to select the correct parts for your axle. However, in some…

view full answer...

Answer 7

I have a great alternative for you. From the installation photos of the DeeZee NXc Running Boards w Custom Installation Kit #DZ16202-16241 for the 2014 Jeep Grand Cherokee, it looks like there is about a 1-1/2 inch gap between the running boards and…

view full answer...

Answer 8

Yes, I can confirm that the DeeZee NXc Running Boards w Custom Installation Kit item #DZ16202-16241 do fit the 2022 Jeep Grand Cherokee WK. The WK is just the older model jeep Grand Cherokee which is why these fit. This includes a custom installation…

view full answer...

Answer 9

When we installed the SumoSprings Solo Custom Helper Springs #SSR-307-47 on a 2013 Ram 1500 we did not use the included spacer. There are really 2 factors that are going to come into play when deciding if you will need the spacer on your 2016 Ram…

view full answer...