Can Mounting Lippert Storage Box LC664640 Attach to 2006 Cameo by Carriage

Question

Question:

Can I mount the storage box to a 06 Cameo by Carriage that has 6inch of frame exposed below the floor?

asked by: Richard A

0

Expert Reply:

Yes the SolidStep Locking RV Storage Box # LC664640 can attach to a 6 inch portion of frame like what you have access to on your Cameo.

expert reply by: Jameson C

0

Answer 1

Yes, you will need to use all three sets of mounting plates in order to safely install and get the full capacity of the Lippert Underchassis Double Bin Storage Unit with Spare Tire Carrier for RVs #LC125460.

view full answer...

Answer 2

Good question; you are right that the SolidStep Locking RV Storage Box - Powder Coated Steel - 100 lbs #LC664640 measures 27 inches long and 11-5/16 inches wide but it also has a large 13-3/4 inch depth, which is a significant amount. The box can…

view full answer...

Answer 3

The SolidStep Locking RV Storage Box part #LC664640 is designed to fill the void left over from the old manual pull-down steps when using the fold-up Lippert SolidSteps. The box itself measures 27-1/4" long x 11-5/16" wide which will fit…

view full answer...

Answer 4

It's hard for me to say whether or not you will need to fabricate special brackets for the Lippert Underchassis Double Bin Storage Unit #LC125460 without knowing exactly where or how long that hard propane line is on your Keystone Cougar. The…

view full answer...

Answer 5

The Lippert Components Flip Down Slotted Bike Rack Tailgate Storage System Item #LC243621 has an length of 70-1/2" so you would need to have a frame distance of 71" to install this on the I-beams with the Lippert Tailgate Storage System…

view full answer...

Answer 6

The Lippert #LC373965 install hardware kit for the #LC243621 flip-down tailgate storage system isn't vehicle specific. The hardware kit is designed to bolt or weld to the 2 inch wide frame extensions, as is shown in the provided photo. If the…

view full answer...

Answer 7

The overall measurements of the Lippert Underchassis Double Bin Storage Unit w/ Spare Tire Carrier #LC125460 is 99-1/2 inches long overall and 23 inches wide at the mounting brackets. The length at the mounting brackets is 78 inches. Please see…

view full answer...

Answer 8

The brackets part #LC373965 that you referenced basically either bolt around or weld to the bumper support beam on the RV. I attached a picture that shows them welded but you could also drill holes in the bumper and use included hardware to secure…

view full answer...

Answer 9

The SolidStep Locking RV Storage Box, #LC664640 has dimensions of 27-1/4" X 11-5/16" X 13-1/2".

view full answer...

Answer 10

Yes, you can install a Curt Trailer Hitch Receiver #C11433 on your 2019 Chevrolet Spark. This receiver is capable of supporting up to 200lbs of tongue weight. With each of the Lectric 3.0 e-bikes weighing roughly 60lbs without the battery you will…

view full answer...

Answer 11

We noticed when we installed the etrailer Trailer Hitch Receiver #e98856 on a similar 2022 Jeep Wrangler it had 8" from the center of the hitch pin to the rear edge of the stock spare tire. This would likely not allow you to fold up the…

view full answer...

Answer 12

The Hollywood Racks RV Rider #HLY64FR has a frame clamp design that was intended for use with step through style bike frame like what your Aventon Adventure bikes have so this rack would work perfect for you. I attached a picture that shows this…

view full answer...

Can Mounting Lippert Storage Box LC664640 Attach to 2006 Cameo by Carriage

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching