Replacement Vacuum Breaker Kit for Dometic 111 Series Toilet

Question

Question:

I just want to make this vacuum breaker will fit my model 111 toilet. Thanks

asked by: Patty

0

Expert Reply:

For your Dometic 111 Series toilet we have a replacement vacuum breaker kit with the part # DOM95FR. The part number you mentioned does not fit as it was designed for a different toilet.

expert reply by: Jameson C

0

Answer 1

For the Dometic 310 series RV toilet we do offer a replacement breaker vacuum kit with the part #DOM95FR.

view full answer...

Answer 2

We do have the Replacement Hand Sprayer for Dometic RV Toilets part #DOM88FR which works with the 310 series toilet that you have. Then for a replacement vacuum breaker you would want the part #DOM26FR.

view full answer...

Answer 3

I contacted Plews and the only suggestion they can give to remove a stuck cartridge is to try to remove it with a pair of pliers. They also mentioned their grease guns like part #L30100 are not compatible with Mystic grease cartridges. You also want…

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 5

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as…

view full answer...

Answer 8

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 9

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 10

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 11

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 12

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Replacement Vacuum Breaker Kit for Dometic 111 Series Toilet

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching