What Replacement Mounting Hardware do I Need for The Tow-Rax Storage Cabinet # TWSPJCA?

Question

Question:

Do you guys have additional mounting hardware for the TWSPJCA? I am looking to mount it in another location and carry the cabinet between the 2 locations.

asked by: Cal

0

Expert Reply:

Yes! For extra mounting hardware for the Tow-Rax Aluminum Storage Cabinet w/ Folding Tray - 22" Tall x 12" Wide # TWSPJCA, you need the Mounting Buttons for Tow-Rax Shelves, Cabinets and Racks - Aluminum # TWSP25BK. In order to mount the buttons in a second location, the units must be either outfitted with Tow-Rax key-punch brackets that come with the # TWSPKPB or pre-drilled to install.

expert reply by: Bob C

0

Answer 1

The Tow-Rax Wall Mounted Folding Table #TWSP45HFTA includes the L-shaped support struts that hold the table in place and allow it to fold down when not in use. You can either do a permanent installation with fasteners you source locally or you can…

view full answer...

Answer 2

When measuring for a trailer cover you want to measure from the front of the trailer box, not the tongue, to the rear including anything that is attached to the rear. This will include a spare or a ladder at the farthest edge at the rear of the…

view full answer...

Answer 3

The Tow-Rax Wall Mounted Folding Table - Aluminum - 45-1/2" Long x 18-1/2" Wide #TWSP45HFTA has the key hole shaped mounting slots to fit over screws, buttons, or pins and remove table by lifting up to release. I've attached a few…

view full answer...

Answer 4

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 5

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

view full answer...

Answer 6

Yes, the lid is available as a replacement part. Based on the part numbers you gave me the correct replacement lid is the #FVK1020-19. For the lift arm you can use the #FVK8011-05.

view full answer...

Answer 7

The B&W Companion OEM 5th Wheel Hitch w/ Slider for Chevy/GMC Towing Prep Package #BWRVK3775 you're looking at will work fine with your new Chevrolet Silverado. This hitch has 3 height adjustments so you'll be able to set the hitch height…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...