WeatherTech Floor Mats for 2012 Winnebago Adventurer Motorhome

Question

Question:

Looking for floor mats for a 2012 Winnebego - Adventure. Will the WTW51TN fit that RV? If not, could you please make a recommendation as to what would fit? Thank you

asked by: Leslie E

1

Helpful Expert Reply:

The WeatherTech All-Vehicle Mat Auto Floor Liners, # 61-11AVMOTHSG are designed to fit virtually all vehicle flooring due to its unique shape and trim-to-fit features. For a vehicle such as your 2012 Winnebago Adventurer, this trim-to-fit floor mat is the recommended option.

expert reply by: Michael R

1

Answer 1

WeatherTech does not make a custom fit floor mat for any Class A motorhomes, but you can use the WeatherTech All-Vehicle Mat #61-11AVMOTHSG since it is a universal floor mat that can be trimmed to fit virtually any application. These mats are easy to…

view full answer...

Answer 2

The wire that runs from the vehicle's battery to the 7-way trailer connector and then from the 7-way trailer connector to the trailer battery should be at least a 10 gauge. If you don't have any 10 gauge wire you can purchase part #10-1-1 by…

view full answer...

Answer 3

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

In regards to the Roadmaster Exact Center Steering Stabilizer part #RM47MR, the stabilizer installs on the front of the steering arm pointed down. I have attached a photo of this below. If this wasn't what you were looking for, please just let me…

view full answer...

Answer 9

The torque spec for the rear U bolts on your 2019 F53 motorhome are dependent on the size. If you have 3/4 x 16 u bolts (and used a 1 1/8" socket to remove the nuts) then they torque to 250 lb-ft. If the u bolts are 7/8 x 14 (and you used a 1…

view full answer...

Answer 10

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

view full answer...

Answer 11

Another wire or harness is not needed on the 2023 Honda CR-V for the install of the Curt 4-Way Wiring Harness #C56370, but you do have to add 20 amp fuse to location #17 in the fuse box.

view full answer...

Answer 12

There is a suspension enhancement option for your 2021 Entegra Vision XL built on a Ford F-53 chassis, but I verified with the manufacturer that the steering stabilizer only fits if you have at least a 24,000 lb GVWR. You're not out of luck…

view full answer...