Will Plastic Bed Liner Need to be Modified to Fit Erickson Ladder Rack on 2020 Ford Ranger
Question:
Hi, my Ranger has a plastic bed liner. Your website says some modification may be needed to install. The installation video on your site also references some finangalling might be necessary to install, but does not mention any drilling is necessary. Are you confident this can be installed on my truck without cutting or drilling?
asked by: Bart P
Helpful Expert Reply:
Since we were able to install the Erickson Truck Bed Ladder Rack # EM07705 on a 2020 Ford Ranger with a plastic drop-in liner and we didn't have to modify anything, I'm very confident that you won't have to modify anything for your application either if you install it in the same locations that we did.
The only reason that we have those disclaimers is because sometimes the mounting locations for those legs can vary depending on the length of the load you need to carry. If the plastic liner happened to be in the way for where you needed the legs of the ladder rack positioned then that's when you might have to do some modification.
Attached is the installation video and a photo of the finished install for you to check out.
(click to enlarge)
Product Page this Question was Asked From
Erickson Truck Bed Ladder Rack w/ Load Stops - Aluminum - 800 lbs
- Ladder Racks
- Truck Bed
- Fixed Rack
- Work
- Aluminum
- Fixed Height
- 800 lbs
- Over the Bed
- No-Drill Application
- Erickson
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Ladder Rack
- Shop: Erickson Truck Bed Ladder Rack w/ Load Stops - Aluminum - 800 lbs
- Video: Erickson Ladder Racks Review - 2020 Ford Ranger
- Shop: Erickson Truck Bed Ladder Rack w/ Load Stops - Steel - 800 lbs
- Search Results: motorcycle
- Search Results: ladder rack
- Search Results: ladder racks
- Search Results: 44649
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - 1 to 2 Axles - Proportional
- Shop: Trailer Hitch
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles
- Article: Trailer Wiring Diagrams
- Video: TruXedo Elevate Truck Bed Rack System Review
- Search Results: dust cap
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Shop: Trailer Wiring
- Video: Choosing the Right Brake Controller
- Q&A: Can I Use Both the 7-Way and 4-Way Connectors at the Same Time on a 2015 Chevrolet Silverado
- Shop: Replacement Inner Member for Dexter DX7.5L Actuator - Single Axle w/ Disc - 2" Ball - 7,500 lbs
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Fifth Wheel Hitch
- Video: Thule TracRac SR Sliding Truck Bed Ladder Rack Review
- Search Results: 68149
- Shop: Brake Controller
- Q&A: Bearings and Seal Used for AL-KO 7290 Trailer Hubs for #99 Spindles
- Shop: Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Video: Choosing the Right Trailer Wiring
- Search Results: 25580
- Article: Replacement Automotive Lighting
on Ladder Racks
