Replacement Cover/Tarp For Extang Trifecta 2.0 Tonneau on 2012 Ram 1500 With 6-1/2 Foot Bed

Question

Question:

I have a 2012 ram 1500 6 foot 4 inch bed with a extang tri fold Trifecta cover. Im looking to replace the cover for the matte black canvas cover. Its this the one that will fit the frame I have now? Let me know when you can.

asked by: Curt T

0

Expert Reply:

You can replace the cover/tarp of the Extang Trifecta 2.0 tonneau cover on your 2012 Ram 1500 with a 6-1/2 foot bed with the same cover, but not a different style (if that's what you were asking). So if you do need a replacement for your Trifecta, it would have to be a direct replacement, and that depends on if your '21 Ram 1500 had the Ram Boxes or not.

- Replacement For Extang Trifecta 2.0 # EX92430 WITHOUT Ram Box: Replacement Tarp For Extang Trifecta 2.0 Tonneau Cover # EX92430-20

- Replacement For Extang Trifecta 2.0 # EX92426 WITH Ram Box: Replacement Tarp For Extang Trifecta 2.0 Tonneau Cover # EX78YV

expert reply by: Kyle S

0

Answer 1

If the rear panel on your Extang Solid Fold 2.0, like part #EX83475, came off and it is still in good condition then you can follow the instructions in the linked photo to reinstall it. If the rear panel is not in good condition then let me know the…

view full answer...

Answer 2

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 5

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 6

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 7

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 8

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 9

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 10

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 11

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 12

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Replacement Cover/Tarp For Extang Trifecta 2.0 Tonneau on 2012 Ram 1500 With 6-1/2 Foot Bed

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching