Replacement Door for Atwood 6 Gallon Water Heater GCH6A-10E

Question

Question:

Does your Replacement Black Door for 6 Gallon Atwood Water Heater, Item # AT91507, fit an Atwood/Dometic Model GCH6A-10ES 6 gallon water heater?

asked by: Stephen C

1

Helpful Expert Reply:

Yes, the Replacement Black Door for 6-Gallon Atwood Water Heater # AT91507 is the correct replacement door for your Atwood GCH6A-10E water heater. We also have it available in white with part # AT91386.

expert reply by: Scott S

1

Answer 1

We have checked with Atwood and can confirm for you that the Replacement Black Door #AT91507 or white #AT91386 are a confirmed fit for your 6 gallon Atwood GC6AA-10E water heater.

view full answer...

Answer 2

The #AT91507 Atwood Replacement Water Heater Door measures 14-5/8 x 18 inches as shown in the provided photo. I've linked you to a product description video featuring the water heater door.

view full answer...

Answer 3

The RV water heater door part #AT91386 does not come with mounting hardware so for that you'd need the cam locks like part #CAM09213 and you'd be set.

view full answer...

Answer 4

Atwood has a 6 gallon water heater you could use to replace the one you have now with the part #DMC74FR and you'd be set. It's slightly different but it's same capacity and would work great.

view full answer...

Answer 5

I went out to our warehouse to take a look at the Atwood Replacement RV Water Heater Door #AT91386 referenced in your question. The door measures 18 inches wide and right at 14-1/2 inches tall. This particular replacement door is designed for the…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 9

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 10

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 11

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 12

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...