Dimensions of 429384 Atwood Replacement Water Heater Door

Question

Question:

What are the measurements for this door? Thanks

asked by: Bobby H

0

Expert Reply:

The # AT91507 Atwood Replacement Water Heater Door measures 14-5/8 x 18 inches as shown in the provided photo.

I've linked you to a product description video featuring the water heater door.

expert reply by: Mike L

0

click to enlarge

Answer 1

Yes, the Replacement Door for Atwood RV Water Heaters #AT91386 installs using two pins at the bottom. It is then secured shut using a Water Heater Door Latch #372225. I have included a picture showing the door attached to the pins.

view full answer...

Answer 2

The water heater you have is a 10 gallon Atwood water heater which is no longer made like you mentioned but what you can do is go with a tankless water heater like the part #FR98SR which offers advantage of never running out of hot water since it…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

The correct replacement for an Atwood Water Heater GC6AA-9E is the Dometic RV Water Heater part #DMC74FR. This is a 6 gallon water heater that works with both gas and electric just like the one you have so it will be an exact match.

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

The first thing you will need for your 1999 D250 is a 4-way. The Curt T-Connector Vehicle Wiring Harness #C55317 plugs into the connection points behind your rear bumper and will allow you to power your trailer's signal lights. Once the 4-way is…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Hey Roy, The only U-bolt kit we currently only offer for 1-1/2" square axles is part #CE23102, which only has a 3-3/8" length so it likely wouldn't be the best option for you. Instead you'll want to order the 1-1/2" Square…

view full answer...

Dimensions of 429384 Atwood Replacement Water Heater Door

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching