Does Replacement Buckle for Extang SolidFold Tonneau Covers EX1018 Come w Male & Female Side

Question

Question:

The title says Replacement Female Tie-Down Buckle but the picture shows the male buckle too. Does it include the male buckle?

asked by: Mark S

0

Expert Reply:

Yes the Replacement Female Tie-Down Buckle for Extang SolidFold Tonneau Covers # EX1018 that you referenced does come with both the male and female side. The male side attached to the strap and the female side you'd attach directly.

expert reply by: Jameson C

0

Answer 1

The length of the male plastic piece of the Replacement Tie-Down for Extang Solid Fold 2.0 Hard Tonneau Covers #EX1024 is 1-1/2 inches. This is the correct replacement tie-down for the Solid Fold 2.0 Series 83-xxx covers. I have added a link below to…

view full answer...

Answer 2

I spoke with a representative from Leer. You need these parts for the Leer Hard Tonneau Cover - Tri Fold - Fiberglass Reinforced Plastic, part #LE49VR, on your 2009 Toyota Tacoma: Prop Rod Assembly, part #Replacement Prop Rod Assembly for Leer…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

First you are going to want to disassemble one of your hubs to verify if you have the #42 Spindle #TRU37FR. I have found this is the spindle some have found but you will need to determine it is what you have and if not you will need to have a pair of…

view full answer...

Answer 5

If you have a 2017 Toyota Tacoma with the tow package/factory 7-way yes it is pre-wired for a brake controller. For a brake controller I recommend the Prodigy P3 Brake Controller part #90195. This is our best selling brake controller because of how…

view full answer...

Answer 6

I have attached a page from the installation instructions for the Extang Solid Fold 2.0 Hard Tonneau Cover #EX83475-62. The page shows the parts that should be used with the rear panel you said blew off. You can look at the page to make sure all of…

view full answer...

Answer 7

Based on your images it appears you have a BAKFlip Tonneau Cover. This will use the Buckle and Strap Conversion Kit #PARTS-356A0009. The Replacement Tie-Down #EX1024 you found is for Extang Solid Fold 2.0 Hard Tonneau Covers which are only 3 panels.

view full answer...

Answer 8

First you will need to determine if you have the Extang Solid Fold 1 or 2.0 on your 2014 Ford F-150, as the update occurred right at the same timeframe your F-150 was made. The best way to tell the difference is by the release handles on the tailgate…

view full answer...

Answer 9

The Replacement Female Tie-Down Buckle for Extang SolidFold Tonneau Covers #EX1018 is the only way to get the buckle for the original Extang SolidFold covers. We do have the Replacement Female Tie-Down Buckle for Extang SolidFold 2.0 Tonneau Covers…

view full answer...

Answer 10

Thanks for the picture! Wthout knowing for sure what model tonneau cover you have, I can't say for sure. However, it does look like this strap will be compatible with your tonneau cover. As long as you have the 83-XXX series Extang Solid Fold 2.0…

view full answer...

Does Replacement Buckle for Extang SolidFold Tonneau Covers EX1018 Come w Male & Female Side

Product Page this Question was Asked From

Continue Researching