Replacement Control Unit for Kwikee 40 Series Steps # 90950800

Question

Question:

Kwikee 40 series 2 tread rv step SN 32745 with high torque motor rv is 2000 Rexhall. Need replacement motor controller, existing is PN-909508000

asked by: Al B

0

Expert Reply:

The correct replacement control unit for your Kwikee 40 series steps PN-90950800 on your 2000 Rexhall RV is going to be the Replacement Control Unit for Kwikee 40 Series Electric RV Steps # LC363985.

expert reply by: Scott S

0

Answer 1

If your Kwikee Series 40 Steps #LC3726891 are stuck in the closed position you could either have a bad motor or control board. You can replace the motor with the Replacement Motor with Mounting Plate for Kwikee Electric RV Steps #LC379608 and the…

view full answer...

Answer 2

I checked with Lippert and the part number you mentioned corresponds with the Revolution Kwikee step and the replacement control module you need then is the part #LC363985.

view full answer...

Answer 3

When the 909508000 part number has come up before it has been in relation to Kwikee 40 Series Steps which use the Replacement Control Unit for Kwikee 40 Series Electric RV Steps #LC363985. Unfortunately your motorhome information doesn't actually…

view full answer...

Answer 4

When the Kwikee 909508000 part number has come up before it has been in relation to Kwikee 40 Series Steps which use the Replacement Control Unit for Kwikee 40 Series Electric RV Steps #LC363985. If those are the Kwikee steps that you have on your…

view full answer...

Answer 5

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 9

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 10

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 11

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 12

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Replacement Control Unit for Kwikee 40 Series Steps # 90950800

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching