Step for a 2019 Chrysler Pacifica Van

Question

Question:

I have a 2019 Chrysler Pacifica van that I’m looking to install a step on the driver and passenger door side to help my elderly mother get in and out. I’m looking for something like this product of yours: Flexco Manual Pull-Out Step for RVs - Single - 3 /Rise - 24 Wide - 300 lbs Do you know if this item or anything similar would work on the Pacifica van? Thanks so much!

asked by: Susie H

0

Expert Reply:

I have a solution for you but no we do not have anything that is designed for your 2019 Chrysler Pacifica van or that can be adapted to it. I recommend the Adjustable-Height, Folding Platform Step item # PA-275. This is a 19" long x 14" wide aluminum platform step that features 4 different height settings. Each leg adjusts independently from 7-7/16" to 8-3/4" tall.

expert reply by: Jerred H

0

Answer 1

I may have different installation method for you, but there is not an extended bracket made to push the TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear #TLA7843 away from your camper to clear your bumper. It may be possible to have a…

view full answer...

Answer 2

I've drawn up a little diagram below displaying the dimensions of the TorkLift GlowStep Stow N' Go Mounting Bracket for Truck Bed Campers #TLA7820. If you need anything else please let me know and I'd be happy to help.

view full answer...

Answer 3

Not following the manufacturer's instructions to the letter will give them an excuse if something were to happen so while I can't recommend drilling the extra holes to ensure it's safely mounted, it's the only way that the steps will…

view full answer...

Answer 4

Yes, you can add a single step to the TorkLift GlowStep Stow N' Go Scissor Steps #TLA7833 you referenced with the part #TLA7801. This will bolt right onto the existing steps with the included hardware and it features the same glow tape as the…

view full answer...

Answer 5

The Lend-a-Hand Extra Large Folding Grab Handle #AM-533 does not have a specific weight capacity. According to Stromberg Carlson, this is only to assist and not weight bearing. Typically this is installed by driving the screws into a stud so it will…

view full answer...

Answer 6

Yes; there is a way to do this. In order to add a step to your TorkLift Glow Step #TLA7803 you can use the Single Add-On Step for TorkLift GlowStep Kits - 20" Long x 8" Deep #TLA7801. This adds a step in the middle and leaves the rest of…

view full answer...

Answer 7

You are correct the Single Add-On Step for TorkLift GlowStep Kits #TLA7801 is the correct part to add a step to the TorkLift GlowStep #TLA7844 that you also mentioned.

view full answer...

Step for a 2019 Chrysler Pacifica Van

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching