Recommended Replacement for G6A-7 Water Heater for 1997 Mallard 19N Travel Trailer

Question

Question:

I have a 1997 Mallard 19N travel trailer that has a bad water heater the model number is a G6A-7 I need a direct replacement to fit in the existing cut out any help would be great thanks

asked by: Rush F

0

Expert Reply:

For a replacement for your G6A-7 water heater I recommend the Fogatti RV Tankless Water Heater - Gas - Automatic Pilot - 41,800 Btu - White # LSB64FR. The cut out dimensions for this water heater are 13" wide x 13" tall x 17-3/4" deep so it will be able to fit in the same space as your G6A-7.

This tankless water heater produces up to 90 gallons of hot water flow per hour and has a wall controller to adjust the temperature. If you would prefer it in black, the # LSB44FR is also available. This water heater will also require the # CAM10423 for installation.

I have attached a review and installation video for your reference.

expert reply by: Robin H

0

Answer 1

The Solera 14' Slider (Slide-Topper) in White w/ White Hardware #LCV000163301 comes with everything you need for installation except the #CAM25013 which is an 8 foot length that is shown in the video as you stated. I do recommend getting two…

view full answer...

Answer 2

Great question but the current MaxxFan roof vents like part #MA00-06401K can be used with lithium batteries. There was an issue with the older models of the MaxxFans but they went to a different circuit board that can handle the higher voltage for…

view full answer...

Answer 3

I am sure we do but I do not have any way of knowing what size cutout your Fleetwood Southwind RV has so you'll need to take a measurement. The Dometic RV Refrigerator Roof Vent Cap and Base item #DMC97FR, you were looking at, is designed to…

view full answer...

Answer 4

There is not a specific size of tape you will need to install a MaxxAir MaxxFan. I recommend using the RV Vent Installation Kit part #CAM25013 which comes with 8' long x 3/4" wide of white butyl tape that should be more than enough for your…

view full answer...

Answer 5

The MaxxAir Standard RV and Trailer Roof Vent Cover #MA00-933066 will fit your Ventline Ventadome Trailer Roof Vent #V2094SP-30. This will allow you to leave your vent open and run the fan even in the rain. You can also leave the vent open when you…

view full answer...

Answer 6

I recommend the Alpha Systems Butyl Tape for RV Weatherproofing #AL28FJ as it's 1" wide to fully cover the flange of your vent. Make sure you overlap the ends to form a tight waterproof seal. You can see me doing this at 2:50 mark in the…

view full answer...

Answer 7

The bolt holes on the top bracket of the CIPA Universal Door-Mount Replacement Mirrors #CM45000-2 are 3-13/16" apart center to center. I have attached a few diagrams showing the measurements for your reference.

view full answer...

Recommended Replacement for G6A-7 Water Heater for 1997 Mallard 19N Travel Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching