What Material is Replacement Override Nut # LC55FR Made of

Question

Question:

What type of material is your replacement override nut made of?

asked by: Dave B

0

Expert Reply:

The Replacement Override Nut # LC55FR that you referenced is made of steel.

expert reply by: Jameson C

0

Answer 1

It sounds like you may be needing the Replacement Override Nut for Lippert Electric Trailer Jack #LC55FR. If you're needing something different, I would be glad to assist you further.

view full answer...

Answer 2

I contacted the manufacturer about the size of the Replacement Manual Crank Handle for Stromberg Carlson Electric Trailer Jacks #SC94VR. They were able to confirm that the handle is in fact a 7/16 socket.

view full answer...

Answer 3

Since you have a Ram brand electric trailer jack the correct replacement manual override crank is the part #EJ-3520-HD that you referenced which is the correct size of 10 mm.

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

Hi Mark; thanks for the question and I have some good news for you as we have the exact 5th wheel to gooseneck adapter to replace the Turning Point pin box on your Jayco Eagle HT 30.5 CKTS. The correct part is the following: - Gen-Y Hitch Shock…

view full answer...

Answer 10

The B&W Companion OEM 5th Wheel Hitch w/ Slider for Chevy/GMC Towing Prep Package #BWRVK3775 you're looking at will work fine with your new Chevrolet Silverado. This hitch has 3 height adjustments so you'll be able to set the hitch height…

view full answer...

Answer 11

Hey Trevor, so the B and W Companion Slider hitch part #BWRVK3400 only fits the B and W Turnoverball gooseneck hitches and would not fit the gooseneck hitch of your 2022 Chevy Silverado 2500 with OEM pucks. The funny thing about the Patriot slider is…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

What Material is Replacement Override Nut # LC55FR Made of

Product Page this Question was Asked From

Continue Researching