What is Overall Length of Replacement Tongue for Yakima Rack and Roll Trailer 8880204

Question

Question:

How long is the tongue. May use it to convert my small utility.trailer to use it to transport my sea kayaks.

asked by: Joe M

0

Expert Reply:

I checked with Yakima and they informed me that the length of the Replacement Tongue for Yakima Rack and Roll Trailer # 8880204 is 69 inches.

expert reply by: Jameson C

0

Answer 1

The Replacement Tongue for Yakima Rack and Roll Trailer #8880204 is 3/16" thick. The overall dimensions are 69-5/8" long x 2" wide x 2" tall.

view full answer...

Answer 2

You'll be pleased to hear the base of the: -Malone Crossbar Conversion Kit for Standard Utility Trailer #MPG475 measures 32" before the bar starts to curve upwards. I have also attached an image showing this measurement for you to check…

view full answer...

Answer 3

We have the replacement 2" x 2" Rack and Roll Tongue #8880204 but if you're needing that inner piece on the Tongue Extension Kit #Y08109 then that's only available with the extension kit so you'll need the whole part number.

view full answer...

Answer 4

I recommend to use the Curt Trailer Hitch Receiver part #C11473 for the 2020 Toyota Prius AWD-E LE which is a confirmed fit for the all wheel drive electric model of the Prius. It also fits the AWD-E XLE model as well. This will give you a Class I…

view full answer...

Answer 5

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 9

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 12

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

What is Overall Length of Replacement Tongue for Yakima Rack and Roll Trailer 8880204

Product Page this Question was Asked From

Continue Researching