Will the Thule Hullavotor # TH897XT Carry a P and H Quest Kayak that Weighs 49 lbs

Question

Question:

I really wish to purchase the Hulavator but note the 40lb weight caution. I have a PandH Quest Kayak which I believe weights 49lbs if I purchase and have an issue will the warranty cover any issues. Should I be aware of any other items,

asked by: Mark R

0

Expert Reply:

Actually the Thule Hullavator # TH898 that you referenced has a 75 lb capacity so it should work well to carry your P and H Kayak that weighs 49 lbs.

I attached a review video for this product for you to check out also.

expert reply by: Jameson C

0

Answer 1

The Thule Hullavator #TH898 requires a set of aftermarket crossbars that extend past the feet of the rack 4 to 8 inches. I tried to find a roof rack for your 2017 Inifiniti Q60 that would work or find info on the factory rack but could not find…

view full answer...

Answer 2

The Thule Hullavator part #TH898 is designed to fit aftermarket crossbars that are square, round and aero in shape. What you will need to do is click the link I attached that will take you to a page that has all of the roof rack options we have for…

view full answer...

Answer 3

You will actually just use the square nuts that come with the Thule Hullavator Pro #TH898 to mount it on your Yakima JetStream bars (see attached photo). I have attached the installation instructions for you to reference for the installation as…

view full answer...

Answer 4

We don't have a video that shows the Thule Hullavator #TH898 being installed on a set of Thule Aeroblade crossbars but I can describe to you the process. I also attached pictures that I took from the install instructions that show how it attaches…

view full answer...

Answer 5

Due to the shape of most kayaks tapering in width on the front and back and the fact that where the Thule Hullavator part #TH898 grabs the kayak is typically at a much narrower width than the widest point of the kayak Thule states that this carrier…

view full answer...

Answer 6

The Thule Hullavator part #TH898 is an assisted-load kayak carrier that allows you to load the kayak at a lower height and then push the carrier and kayak up onto the roof. It's a great solution, but you need to have an aftermarket roof rack…

view full answer...

Answer 7

Thule recommend you have at least 4 to 8 inches of bar on the outside of the feet of the rack for the Hullavator part #TH898 to clear the side of the vehicle. Ideally when folded down you want at least 4 inches between the rack and the door of your…

view full answer...

Answer 8

The correct weight of the Thule Hullavator Pro #TH898 is 39.7 pounds The weight capacity of a roof rack will limit how much can be carried on it for sure. As will the weight capacity of the vehicle's roof which is often less than the rack and the…

view full answer...

Answer 9

I spoke to my contact at Thule and she informed me that when the Thule Hullavator Kayak Carrier part #TH898 that you referenced is extended down for kayak loading it will be 40 inches lower than the top of the roof rack crossbars. So that means if…

view full answer...

Answer 10

You are going to first need a roof rack system that will give you cross bars that will run from side to side of your vehicle roof. To see the roof rack I recommend check out the link I provided. Once you install the rack you will be able to install…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...