Can I Paint the Americana Trailer Wheel Center Cap # AM90077?

Question

Question:

are these caps paintable

asked by: Russell V

0

Expert Reply:

Technically, you can paint the Americana Trailer Wheel Center Cap - Stainless Steel # AM90077. In order to do so, you must first clean it with soap and water, sand it with fine-grain sandpaper, and then prime. Following these measures, you'll only have success with dedicated metal paints or multi-surface paints labeled for use on metal. Unfortunately, we do not carry paint here at etrailer.com.

expert reply by: Bob C

0

Answer 1

You are correct that is a 3,500 lb axle. If you want a bearing kit the #BK2-100 you looked at is the right one. This comes with a #L44649 outer and #L68149 inner bearing along with a #58846 (10-19) grease seal. If you want a replacement idler hub you…

view full answer...

Answer 2

I do have some options for you but there isn't a plug under the dash for a trailer brake controller on a 2023 Chevrolet Traverse. Therefore, if you want to use a traditional dash mounted trailer brake controller you must hardwire which requires…

view full answer...

Answer 3

According to what Progressive Dynamics recommends, the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4560K18LS8 is the correct replacement for your WFCO WF-9960 converter.

view full answer...

Answer 4

To measure the pilot hole on your wheel, you will need to remove the cap in the picture and then measure the inside diameter of the hole in the wheel. Most wheels with the bolt pattern you have in the photo are 4.88 inches or 4.9 inches with a select…

view full answer...

Answer 5

The Dexter Hydraulic Trailer Brake Kit #23-342-343 is the correct kit for you. This hydraulic drum brake assembly is designed for use with your surge-type trailer brake actuator. The brake's free-backing design lets you reverse without trailer…

view full answer...

Answer 6

For the complete brake assemblies, you would want the Titan Hydraulic Brake Kit - Uni-Servo - 12" - Left and Right Hand Assemblies - 6,000 lbs #T2351100-000. For the wheel cylinder replacements you will want the right hand #AKBRKR-H7-R and left…

view full answer...

Answer 7

Yes everything you mentioned would work well together on your 2003 Keystone Cougar 276 with a 33 inch wheelbase. The EZ Flex equalizer kit part #K71-652-00 would give you a more cushioned ride quality than you have now, would work great with the…

view full answer...

Answer 8

The upgraded equalizer kit I recommend for you is the E-Z Flex Heavy Duty Rubber Suspension System part #K71-652-00 which will be an exact fit for the 5-3/4" long equalizers that you have now. The E-Z Flex Heavy Duty Rubber Suspension System are…

view full answer...