Synthetic Rope Winch for Enclosed Trailer with Drag Truck

Question

Question:

I have a 32’ enclosed trailer that I want to put a synthetic winch in for my drag truck. Truck will probably weigh 3500-4000lbs. I’ve seen a lot of choices but they seem to be overkill for the weight I have unless I’m calculating wrong. Can you suggest a few that would work? Thanks!

asked by: Jim

0

Expert Reply:

For your enclosed trailer the Bulldog Winch Trailer Winch part # BDW15020 would be a great option for pulling in your drag truck as it has a 4,400 lb capacity and was designed for this type of application.

Or if you wanted something that would work a little faster the ComeUp trailer winch # CU645010 would be a really great option. It has a faster motor with a higher capacity which is what allows it to be faster.

expert reply by: Jameson C

0

Answer 1

I recommend using a Winch #SW39GR with the Hitch Mount #BDW20011. This way you only need a 2" receiver which is typically already on the rear of most trucks and are available for the front. For your tilt trailer you can weld on a Receiver…

view full answer...

Answer 2

I would be happy to recommend a winch for your enclosed car trailer. I recommend the Bulldog Winch Trailer Winch - Synthetic Rope - Hawse Fairlead - 4,400 lbs #BDW15020 which will be plenty strong to roll your 2700lb car into the trailer as it has a…

view full answer...

Answer 3

A diode like the part #RM-690 is a great idea but the only issue is that is has a max load of 85 amps. A standard 5,000 lb winch, like the ComeUp DV-5000si #CU645010, will greatly exceed the 85 amp rating of the diode so it would be useless. What you…

view full answer...

Answer 4

Unfortunately the ~16 gauge wires used on a 4-pole trailer connector would deliver only a fraction of the power required to run a winch. There are two basic alternatives, as you stated. You could run a cable from the battery back to the truck,…

view full answer...

Answer 5

The Bulldog Winch part #BDW15020 would be a great option for your setup. This is a 4,400 lb 12 volt winch which uses a synthetic rope instead of a steel cable. It powers in and out and has a built in brake as well. The winch also moves at 19 feet per…

view full answer...

Answer 6

You can put a battery inside the trailer but you would want to place it in a box of some kind since batteries have gases and chemicals in them. We have different battery boxes depending on the size you will need. I have included a link to them for…

view full answer...

Answer 7

In order to power the Bulldog Winch Trailer Winch part #BDW15020 from the vehicle's battery I recommend using the Bulldog Winch Rear Wiring Kit part #BDW20206 which contains 20' of 2 AWG power and ground wire in addition to quick disconnects…

view full answer...

Answer 8

In regards to choosing an electric winch, there are several factors that go into choosing the correct option. I have attached a help article which goes into more detail about each of these. The ComeUp UW-5000si Trailer Winch part #CU645010 would…

view full answer...

Answer 9

We have the Bulldog Winch part #BDW15020 that was designed for mounting to a trailer like you have and would be a great option for pulling a vehicle up onto a trailer. It has a 4,400 lb capacity which would be more than enough for a 3,000 lb car.

view full answer...

Answer 10

You would want to go with a deep cell battery. Having a battery larger than you would need would be the way to go as having a battery that is similarly rated as the draw of the winch will drain it quickly. We don't carry any deep cell batteries…

view full answer...

Answer 11

The Bulldog Winch Trailer Winch - Synthetic Rope - Hawse Fairlead - 4,400 lbs #BDW15020 you were looking at is a fantastic choice for your enclosed car trailer and will pull your 3000lb race car very easily as it has a rolling capacity of 44000lbs on…

view full answer...

Synthetic Rope Winch for Enclosed Trailer with Drag Truck

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching