Lippert Ground Control 3.0 Will Not Retract

Question

Question:

My jacks will not retract. What do I do? Tried resetting the control but nothing happened

asked by: Steve S

0

Expert Reply:

If you have reset the system and they are still not retracting, you will need to check a few things. First will be the fuses. If one or more of these have failed, it can cause the system to not function properly. Next will be ground connections. A bad ground can cause any number of weird things to happen and this will definitely fall under this. You will need to make sure all the grounds have good solid connection to bare metal.

However, if all the fuses and grounds are good, you will need to replace your Control Module for Lippert Ground Control 3.0 Electric Leveling System # LC304136, unfortunately. These do go bad over time and is most likely the issue you are running in to.

expert reply by: Lazer S

0

Answer 1

I am sorry to hear about the issue you are having with your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part #LC358590. The first thing you are going to want to do is check for blown fuses on the control board. If the fuses are…

view full answer...

Answer 2

It sounds like the switch in the jack is bad and should be replaced. Typically when an electric jack will go one direction but not the other its because the switch is broken. You might try checking all the fuses on the jack also. Since your trailer…

view full answer...

Answer 3

I reached out to my contact at Lippert and they said that it sounds like you just aren't holding the 4 buttons for the reset long enough. It requires 5 seconds, but many people will count to 5 a little too fast and the system won't…

view full answer...

Answer 4

It actually is just that, an antenna. I spoke with my contact at Lippert who said that some models of the Lippert Ground Control 3.0 #LC358590 are wireless. The antenna on the Control Module #LC304136 is there for those systems.

view full answer...

Answer 5

It could be a loose wiring connection or corrosion, or you could have a damaged wire. You can check out the attached wiring drawing to see what you can check to try and find the problem. To correct the system errors I have attached the chart that…

view full answer...

Answer 6

I called my contact at Lippert about reprogramming the remote for your Ground Control 3.0, part #LC358590 when you install the replacement control module, part #LC304136. In the service manual you will need to follow the instructions for Homing…

view full answer...

Answer 7

Thank you for the picture of the module your Lippert Ground Control kit has as I can tell from it that you have a 4 point kit. So for a replacement control module you'd want the part #LC304136. The "points" refer to the…

view full answer...

Answer 8

I assume you have the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part #LC358590? If that is the case then there is a manual override on both the top of the motor and bottom of the leg for each jack. Since the jack is retracted…

view full answer...

Answer 9

If you're getting a RR or LR fault code with your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote #LC358590 or #LC675817, then that is indicating that there is an error at that specific jack (right rear…

view full answer...

Answer 10

If the Lippert Ground Control part #LC675817 display screen is displaying an error that says "Return Leveler for Service" then you should be able to just clear the code. There is not any specific information on why this error code…

view full answer...

Answer 11

I'd try a reset first. To manually reset your Lippert Ground Control part #LC358590 you need to hold down the retract and enter buttons at the same time. Try that but if you still get an error code you most likely have a low voltage battery…

view full answer...

Answer 12

I spoke to my contacts at Lippert and the shafts of the jack legs are not available separately. You would have to replace the jack legs. They also have not heard of the shafts breaking either. If you need a replacement left rear leg you would need…

view full answer...

Lippert Ground Control 3.0 Will Not Retract

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching