Wire Gauge of Replacement MC4 Negative Cable for Go Power Solar Charging Systems GP34ZR

Question

Question:

what is the wire gauge of this MC4 cable? amp rating? will it have DC voltage ?

asked by: JAMES E

0

Expert Reply:

The Replacement MC4 Negative Cable for Go Power Solar Charging Systems # GP34ZR is 10 gauge wire, there is not a specified amp rating as they are replacements used with the Go Power solar controllers which are rated for amps, and it does not have DC voltage it connects between the controller and solar panel.

I have added a link below to a video review for you to check out as well of the Replacement MC4 Negative Cable for Go Power Solar Charging Systems # GP34ZR.

expert reply by: Kyle S

0

Answer 1

The circuit breaker I recommend is the 40-amp circuit breaker #9510, it is .66 inches long and may fit inside a junction box easier. However, the place I would mount it is between the charger and the battery on the trailer side. The junction box I…

view full answer...

Answer 2

We don't have an install video for the EcoHitch front hitch part #EH37FR yet but I did attach the diagrams I took from the install instructions that show where you'll trim and what saw to use.

view full answer...

Answer 3

If you install the EcoHitch Hidden Front Mount Trailer Hitch Receiver #EH37FR on your 2022 Ram 3500 you won't be able to install a front grille guard due to the mounting brackets getting in the way of each other. This is the case with any truck…

view full answer...

Answer 4

It really is going to depend on the demands you put on your battery. The 125 amp hour capacity of your battery is a great storage solution so your goal will be to put back into the battery what you are taking out of it. Take the Go Power Weekender…

view full answer...

Answer 5

I contacted the manufacturer to confirm that the Go Power Overlander Expansion Kit #34282182 could be added to your Go Power 170W panel on your RV with the GP-PWN-30 controller. They were able to inform me that you could add up to 2 of the Go Power…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

I checked with the manufacturer for you, and the 12V, 10.7 Cu Ft Everchill RV Refrigerator w/ Freezer #EV77FR needs 160 Watts and two group 27 batteries for constant use. Keep in mind that power is only for the fridge though and not all your other…

view full answer...

Answer 10

The thickness of the Alpha Systems Superflex TPO RV Roof Membrane #AL55CV is approximately 0.03", which is roughly the same thickness as a credit card. This is the typical thickness for all RV roof membranes on the market.

view full answer...

Answer 11

There is indeed a front-mounted trailer hitch that fits your 2024 Ram 2500, from Curt, at the following part number: - EcoHitch Hidden Front Mount Trailer Hitch Receiver #EH37FR I verified this fit directly with the manufacturer for you, and it fits…

view full answer...

Wire Gauge of Replacement MC4 Negative Cable for Go Power Solar Charging Systems GP34ZR

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching