Socket Size Needed To Manually Retract A Slide Out On A 2009 Gulf Stream Conquest Travel Trailer

Question

Question:

What type and size socket is supposed to be used if you want to use a cordless drill driver to retract slideout? Thanks,

asked by: Patrick

0

Expert Reply:

To manually retract your slide-out you'll need to use a 5/8" socket on your Gear Motor Assembly for Lippert Electric Slide-Out # LC386327.

expert reply by: Kevin C

0

Answer 1

There is a chance that your trailer has a manual override built into it. I would recommend you check with your manufacturer before you try the following steps. The first thing you are going to want to do is find the slide-out motor. The motor is…

view full answer...

Answer 2

The best spot to install the Trailer Connector is on the bed sidewall on the drivers side, between the wheel well and the tail gate. We have an installation video showing this Curt 5th Wheel and Gooseneck Wiring Harness #C56000 being installed on a…

view full answer...

Answer 3

I checked with Lippert and was able to determine that the Replacement Gear Motor Assembly for Lippert Electric Slide-Out #LC386327 you were already looking at is going to be a compatible replacement for your PowerGear 521066W slide out motor.

view full answer...

Answer 4

The Replacement Gear Motor Assembly for Lippert Electric Slide-Out #LC386327 is the correct replacement for the Power Gear Slide-Out Motor model no. 348582.

view full answer...

Answer 5

We've checked with Power Gear in the past with your slide out motor number 521066W and found that the correct replacement is the part #LC386327. This would have same performance capabilities as what you have now.

view full answer...

Answer 6

The correct replacement slide-out motor for a Power Gear 523725 is the Replacement Gear Motor Assembly for Lippert Componenents Slide-Out part #LC386327.

view full answer...

Answer 7

We can absolutely tell you the correct replacement for your 13-1115 slide-out motor; I verified for you the correct replacement part is the following: - Replacement Gear Motor Assembly #LC386327

view full answer...

Answer 8

I contacted the manufacturer, Lippert, about this and they gave me a spec sheet with all of their available information about the Replacement Gear Motor Assembly for Lippert Electric Slide-Out #LC386322, which you can see. This motor operates at 15…

view full answer...

Answer 9

The Lippert Components RV Slide-Out Motor by Klauber #LC130057 does have the electric brake on it that does act like a clutch to keep you from over-extending or over-retracting the slide and causing any damage to the motor or frame. I'm not sure…

view full answer...

Answer 10

Yes, the Air Distribution Box w/ Wall-Mounted Thermostat for Advent Air RV Air Conditioners #ACRG15 is what you need for your application. This includes a new thermostat as well. According to my research all of the wiring for your current thermostat…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Socket Size Needed To Manually Retract A Slide Out On A 2009 Gulf Stream Conquest Travel Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching