Replacement Lid for MaxxFan 4401K Roof Vent

Question

Question:

Do you know the part number for a replacement lid for the MaxxFan 4401KJ?

asked by: Donnie S

1

Helpful Expert Reply:

For the MaxxFan 4401K roof vent the correct lid is the part # MA10A40009K.

expert reply by: Jameson C

1

Answer 1

The correct replacement lid for a MaxxAir MaxxFan Plus 4951K/4951KS is the Replacement Lid for MaxxFan and MaxxFan Plus Roof Vents part #MA10A40009K for smoke or part #MA10A40002K for white.

view full answer...

Answer 2

The correct replacement roof vent lid you need for the MaxxAir roof vent you have in your RV is the part #MA10A40009K.

view full answer...

Answer 3

Yes, the correct replacement lid cover for your MaxxFan Plus Roof Vent w/ 12V Fan part #MA00-04500K (4951KS) is the Replacement Lid for MaxxFan and MaxxFan Plus Roof Vents part #MA10A40009K.

view full answer...

Answer 4

We have the black replacement MaxxFan replacement lid part #MA10A40009K or the white part #MA10A40002K.

view full answer...

Answer 5

The model number for fans such as the MaxxAir MaxxFan Mini Roof Vent, #MA00-04401M is listed on the upper side of the assembly itself. Please see the attached image. You will best identify this by opening the vent and climbing on top of the RV.…

view full answer...

Answer 6

The MaxxFan #MA00A04401K would be a good replacement fan for most any camper. It fits a standard 14X14" opening and features 4-speed exhaust fan, manual lift design, removable bug screen and sealed motor. A new inside ceiling trim piece…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Replacement Lid for MaxxFan 4401K Roof Vent

Product Page this Question was Asked From

Continue Researching