Jensen AWM 950 Stereo Replacement

Question

Question:

Will the jensen awm950 directly replace the 910.... connector pin out and faceplate mounting holes locations?

asked by: Ron

0

Expert Reply:

Yes the Jensen RV Stereo # JWM60A is in fact a direct replacement for your Jensen AWM950. You will not have to cut or modify anything for installation due to the products having the same dimensions at 9" tall, 6" wide and 5 1/2" deep.

expert reply by: Bryce D

0

Answer 1

We have not had a chance to install the Buyers Products Door Check and Hold #337BM2395AA11 you were looking at, but I would be happy to go over the installation process. The section of the unit that has the spring will need to get mounted to the…

view full answer...

Answer 2

I linked a wiring guide for the Jensen Stereo part #JWM60A which details pin position, wire color and function. For your old stereo model AWM910 I also linked that model's wiring guide page from the owner's manual.

view full answer...

Answer 3

The part of the Buyers Products Door Check and Hold Back #337BM2395AA11 with the spring needs to be mounted to your door frame (at the top) while the arm without the spring needs to be mounted to your door. I have attached a photo showing the…

view full answer...

Answer 4

Between the two stereos the 12 volt trigger wire and 12 volt remote wire are the same circuit so that wire. The rest would wire up the exact same. There should be an other 12 volt DC power wire connection to make on the #JWM60A though. Basically…

view full answer...

Answer 5

The wiring harnesses are different between your Jensen AWM960 and the Jensen #JWM60A so you will have to splice the wires in to install this stereo. I've attached the wiring guides for both systems to help you during this installation.

view full answer...

Answer 6

Your Jensen stereo part AWM970 that you have currently has a more traditional power wire setup where one wire carries 12 volts to power the stereo and the other carries a 12 volt signal wire that only is hot when the key of the vehicle is on to…

view full answer...

Answer 7

Both the Jensen JWM6A and the current model, part #JWM62A are classified as double-DIN head units, which will both use the same sized rough openings in a vehicle dash. The old #JWM6A and the current model #JWM62A both use the same pigtail, as you can…

view full answer...

Answer 8

For some reason RV stereo manufacturers make every one of their stereo wiring harnesses different to make the consumer work harder than they need to. There isn't an adapter available to switch from your old AWM910 to your new Jensen RV Stereo…

view full answer...

Answer 9

The service pack you reference for your Jensen JWM6A RV Stereo, has been discontinued, which means that there isn't a replacement remote available. Instead, my best advice is to replace your Jensen RV stereo. I recommend the Jensen RV Stereo…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...