Replacement Wheel Strap for Thule T2 Pro XTR Bike Rack

Question

Question:

Can the strap for the T2 pro be purchased individually?

asked by: Bryce

0

Expert Reply:

Unfortunately, Thule doesn't offer an individual replacement wheel strap for their 9034XTR T2 Pro XTR bike rack which we sell as part # TH83JV. The only way to obtain a replacement strap is to purchase the replacement wheel holder assembly you'd looked at, part # 7521682001

expert reply by: Mike L

0

Answer 1

There are many different key codes that Thule uses on their products like the Thule T2 Pro and the Thule T2 Pro XTR #TH83JV. Unfortunately, if you currently do not have a key for the rack and cannot read the cylinder code, the only way forward is to…

view full answer...

Answer 2

I have a solution for you. You can't convert the Thule T2 Pro XTR 2 Bike Platform Rack #TH23JV to a 2 inch hitch according to my contact at Thule so you will need to use an adapter. I recommend using the Brophy Hitch Reducer 2" to…

view full answer...

Answer 3

For the Thule T2 #TH9034XTS the only way to get a replacement rear strap is with a new rear wheel holder assembly part #7521682001 which is compatible with fat tires up to 5 inches in width. The strap you referenced #8527642001 is for the Thule T2…

view full answer...

Answer 4

I checked with Thule and they do not offer just the rubber pad that's on the strap that comes with the #7521682001 so you'd have to order the entire assembly.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Replacement Wheel Strap for Thule T2 Pro XTR Bike Rack

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching