Replacement Cover for Extang Classic Platinum Tonneau Cover 7725

Question

Question:

Hello Etrailer, I need to replace my ExTang Black Mx Snap on Tonneau cover, you offer Part number EX1905. The Mfg number on my cover is: 011507 7725, I am trying to find out if the part you sell will fit. Best Regards

asked by: Charles B

0

Expert Reply:

The number you gave - 011507 7725 - indicates your tonneau cover is the 7725 Extang Classic Platinum, which is also a snap-on, roll-up, soft tonneau cover just like the Black Max, and we do have the correct replacement cover for the 7725, which is the following:

- Replacement Cover for Extang Classic Platinum Snap On, Roll-up Tonneau Cover # EX6725

expert reply by: Kyle S

0

Answer 1

The most probable cause for the lights on your Ultra-Fab electric tongue jack to blink, and for the jack not to operate, is a weak battery and/or grounding problem. This jack grounds through its round mounting flange which contacts the trailer frame.…

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

The mounting holes in the No-Drill Mount Kit #F2530 don't line up perfectly to mount the Air Command II Xtreme Duty Compressor #F2549, but they are close enough that you can widen the holes a bit to accommodate the compressor and avoid drilling…

view full answer...

Answer 5

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 6

Yes, it will so long as your Ford key looks like one in the picture below. The Replacement Lock Cylinder for BOLT Toolbox Latch item #BLT79FR only works with Bolt tool boxes.

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 10

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Replacement Cover for Extang Classic Platinum Tonneau Cover 7725

Product Page this Question was Asked From

Continue Researching