Replacement Switch for Slide Out

Question

Question:

I need to find a switch for the bedroom slide in our 2004 Bounder 38N. I did not see one on the website that looks the same. Is there one that would work in place of the OEM switch?

asked by: Mark M

0

Expert Reply:

I do not ahve the abilty to pull an OEM build sheet for part numbers however, we have a couple options available. The Single Slide-Out Switch, # 37212285 is a 12V 40-amp continuous/momentary switch assembly. With cutout dimensions of 1.85" tall x 1.20" wide.

If you have a Lippert Components Slide-Out then I recommend the Lippert Hydraulic Interior Switch, # LC120639.

expert reply by: Michael R

0

Lippert Hydraulic Interior Switch
(click to enlarge)

Answer 1

I checked with Draw Tite and the size bolt recommended for the mounting holes of the brackets #4916 is 5/8 inch which is the diameter of the holes.

view full answer...

Answer 2

The mounting plates included with the Curt Class V Universal Weld-On Receiver #15903 you were looking at are slightly different that the 16" Weld-On Bracket Kit #4916 you mentioned. Our warehouse measured the #15903 brackets and they measure…

view full answer...

Answer 3

We do carry universal hitches that are rated for 10,000 pounds and above, like the Draw-Tite part #41990-07. I've linked the selection. With that being said a lot of times when a motorhome is rated for 5,000 pounds towing it isn't the hitch…

view full answer...

Answer 4

I went ahead and found a wiring diagram for the Single Slide-Out Switch #37212285, and you are going to need to just match the hot from your trailer to the power (+) pin, and then match the green and blue wires to the motor (+) pins. I have attached…

view full answer...

Answer 5

We have the Lippert Components Slide-Out Switch Assembly - Black #LC117460 or white #LC117461. As far as your motor goes, you will need to look at your assembly and give me the number on your assembly for the correct replacement. I've linked the…

view full answer...

Answer 6

My contact at Lippert Components advised that their Interior Slide-Out Switch #LC120639 does indeed have three male tabs on the rear surface for electrical connection to your RV's slide-out.

view full answer...

Answer 7

There is no way to know for us to know the exact slide out you have on your 2006 Forest River Wildwood and switches aren't made for specific campers, they are made for the slide out. So if your Wildwood has a LCI (Lippert Components) Above-Floor…

view full answer...

Answer 8

If you take a look at the accompanying photo, you can see the correlations between color and function of the Lippert Components Slide-Out Switch Assembly - Black #LC117460. The black wires are ground, red is power, yellow is extend, and green is…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Replacement Switch for Slide Out

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching