Standard Faucet to Replace Empire Faucets Quick Disconnect RV Outdoor Shower and Kitchen Faucet

Question

Question:

Have this in our RV Shower Sink Combo. What other fixture part would work/fit to replace the gooseneck faucet? Or replace the entire fixture? re: 2021.5 Geo Pro 20BHS camper

asked by: Lorene B

1

Helpful Expert Reply:

You could use more of a standard faucet to replace the # EM74JR like with the # PF223502 since its the same foot print. But if you were wanting to go a different direction than that you'd have to let me know.

expert reply by: Jameson C

1

Answer 1

The Replacement Dual Handle Faucet #PF213790 uses the standard 1/2 inch thread size found on faucet plumbing.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 4

Yes, the lid is available as a replacement part. Based on the part numbers you gave me the correct replacement lid is the #FVK1020-19. For the lift arm you can use the #FVK8011-05.

view full answer...

Answer 5

I did some looking and found that the 46210 and 46845 hubs you currently have use the same #L68149 inner bearing and #L44649 outer bearing. However, as we do not carry the Tie Down Engineering Vortex hubs, I cannot say what all will fit them,…

view full answer...

Answer 6

The Dexter 8-427 hub is no longer available. Even looking through Dexter's site the only references to it are replacement bearings. You can use a wheel with a larger pilot hole as long as the wheel attaches to the hub using lug nuts and not…

view full answer...

Answer 7

Hello Gaby. I reached out to the manufacturer and found out that the UltraFab Weld-On Jumbo Steel Roller #UF48-979023 uses a 6-1.0mm Zerk fitting. For a replacement you can use the following: - Replacement Brass Grease Zerk for Weld-On Hinges - 6 mm…

view full answer...

Answer 8

A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.

view full answer...

Standard Faucet to Replace Empire Faucets Quick Disconnect RV Outdoor Shower and Kitchen Faucet

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching