Will The Thomas Payne Swivel Glider RV Recliner Fit Through My Door

Question

Question:

Door size for rv swivel chair. It looks like you can take the seat portion and curve it around your door opening - ours is 22 1/2 is the seat height 20 inches

asked by: Cathy

0

Expert Reply:

For the Thomas Payne Swivel Glider RV Recliner w/ Heated Seat, Footrest - Grantland Doeskin, # 195-000029, we show that a 26" door width is needed. Please note the attached product review video, door dimensions discussed starting at the 6 min mark. The distance from floor to top of seat is 20-1/2".

expert reply by: Michael R

0

Answer 1

Trailer wiring generally uses 16 gauge wire, part #16-1-1. However, with a long trailer like yours you may want to go with a larger like 14 gauge #DW07550-1 or even 12 gauge #12-1-1. Each size is sold by the foot. You will need to have the lights…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

It's a wire color difference but not a function difference on the pins of the 7-way. The difference comes from the fact that the two different styles are representative of two different areas that uses trailers. Traditional is usually seen on…

view full answer...

Answer 5

The MORryde Cushioned 5th Wheel Pin Box for 14K to 18K Trailers w/ Lippert Rhino Item #MR83QR is the replacement for your Lippert Rhino pin box.

view full answer...

Answer 6

Since you are replacing the your Dometic Duo-Therm 59016.526 and the thermostat I recommend using the Furrion Chill HE RV Air Conditioner System #FR55PV. This is also a 15K btu system which includes a new roof mounted AC, air distribution box,…

view full answer...

Answer 7

As long as you are not exceeding the tongue weight rating of the trailer hitch receiver or dual hitch receiver adapter, you will not have any issues adding your 150lb accessory with the adapter as is, but I do not recommend modifying the adapter in…

view full answer...

Answer 8

It sounds like you're referring to a bike rack like the Swagman Traveler XCS #S64664, which is designed specifically to fit over the 2" shank of a ball mount or tow bar (see attached image). If you have an existing Swagman rack that slides…

view full answer...

Answer 9

The spacing between the back of the upper receiver and the hitch pin hole is 6-1/2 inches, which wouldn't be long enough for your needs. The Malone #MPG544 dual hitch adapter has a longer shank, and might be a good option for you. The #MPG544…

view full answer...

Answer 10

I recommend the Roadmaster Dual Hitch Receiver Adapter, 10" Drop/Rise item #RM-077-10. This adapter was designed for this type of set up. Your Jeep Rubicon and Swagman E bike rack weigh well below the 10,000 lbs maximum capacity of this hitch. I…

view full answer...

Answer 11

Good questions, and the chatter you are hearing is really about moisture getting in and affecting the circuit boards, but I can tell you with all honesty that is not just a MaxxFan thing; it's something that can and will happen to RV vents,…

view full answer...

Will The Thomas Payne Swivel Glider RV Recliner Fit Through My Door

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching