Troubleshooting Vehicle Trailer Connector Running Light Circuit Not Active on 2016 GMC Yukon
Question:
tail light pin not hot on car side. 2016 yukon
asked by: Jack P
Expert Reply:
If you're not getting power on the tail light circuit of your 2016 GMC Yukon, I recommend starting by checking the fuse for that circuit, which should be located in the engine compartment fuse box in slot 41. If you can give me a little bit more information as to whether you've got a factory 4 or 7 way, I can give you some more specifics to check out if the fuse isn't the issue.
If it comes down to it and you need to replace any of the wiring on the harness you could use the # 16-4B-1. I've also linked some helpful articles on troubleshooting 4 way and 7 way wiring harnesses as well, that you can have a look at as well.
Products Referenced in This Question
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Parts Needed For Flat Towing a 2024 Ford Maverick Behind a 2010 Winnebago Journey With Air Brakes
- Q&A: Caliper Bolts for AL-KO/Hayes Disc Brake Caliper BP18-050
- Q&A: Replacement Oil Seal for AL-KO 568303
- Q&A: Does The Progressive Dynamics PD4655V Have A Lithium Jumper
- Q&A: Which Instructions Are Used Installing a Roadmaster Brake-Lite Relay in a Ford F-150 w/ Neutral Tow
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Diode for Charging Line From Motorhome to Towed Vehicle (Toad)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Maintenance Schedule
- Q&A: What Gauge Wire does 4-Way Trailer Wiring Use
- Article: Trailer Tire Sizing
- Article: Flat Towing Package for 2014-2015 Chevrolet Equinox