Do The Custer LED Side Marker/Clearance Lights Require a Gasket to Install?
Question:
I just purchased two Custer LED Side Marker - Clearance Trailer Lightsfoot Item no. CPL120A. The description indicates surface mounting hardware is not included. I assumed this was the nut and bolts needed to attached the light to the trailer. However when I recieved the light it appears that there should be a rubber gasket or similar that should be placed between the light and the mounting surface. Do you sell this part? Please provide a part no. and cost for this item. I am in need of two pieces. Thank you
asked by: Randy C
Expert Reply:
The Custer LED Side Marker or Clearance Trailer Light # CPL120A doesn't require a rubber gasket. The wiring and LED's are sealed completely and there is no need for a gasket.
If you are running the wiring into the wall be sure to use silicone to seal the hole where the wire enters the trailer to prevent any water damage.
(click to enlarge)
Product Page this Question was Asked From
Custer LED Side Marker or Clearance Trailer Light - Submersible - 16 Diodes - Amber Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 4L x 2W Inch
- Amber
- Custer
more information >
Continue Researching
- Shop: Custer LED Side Marker or Clearance Trailer Light - Submersible - 16 Diodes - Amber Lens
- Shop: Miro-Flex Thinline LED Trailer Clearance or Side Marker Light - Sumbersible - 4 Diodes - Amber Lens
- Shop: Custer LED Side Marker or Clearance Trailer Light - Submersible - 16 Diodes - Red Lens - Qty 1
- Shop: Miro-Flex LED Trailer Side Marker Light and Mid-Ship Turn Signal - Submersible - Amber Lens
- Shop: Lippert Replacement Hydraulic Cylinder for RV Slide-Out
- Shop: Replacement Gear Pack for Lippert RV Slide-outs w/2-1/2" x 2-1/2" Arms - Heavy Duty
- Shop: Replacement Gear Pack for Lippert RV Slide-outs w/ 2" x 2" Arm - No Roll Pin Assembly
- Search Results: led tail lights
- Video: Review of Optronics Trailer Lights - Waterproof Amber Trailer Light - OPT78FR
- Video: Optronics Trailer Lights - Clearance Lights - STL175AMFB Review
- Video: Command LED Trailer Tail Light Installation
- Video: Optronics Low Profile LED RV Tail Light Review
- Video: Optronics Trailer Lights - Clearance Lights - MCL63AB Review
- Video: Review of Custer Trailer Lights - Submersible Amber Lens LED Side Marker Clearance Light - CPL120A
- Video: Review of Lippert Components Heavy Duty Slide-Out Gear Pack - RV Exterior - LC123356
- Search Results: mcl49ab
- Search Results: mcl86ab
- Shop: Vehicle Lights
- Search Results: rv scare light
- Search Results: 2057 bulb
- Search Results: rv fresh water tank
- Search Results: fresh water tanks
- Q&A: Cross Reference a Replacement for a TCM 21334 TB Grease Seal
- Q&A: Can Red Identification Light Bar be Used as Marker & Reverse Lights
- Q&A: Can a Pintle Hook Mount be Used in the Rise and Drop Positions
- Article: Trailer Wiring Diagrams
- Q&A: Installing LED Clearance Lights With 2 Wires
- Q&A: Difference Between Dexter Axle Grease Seals 010-036-00 and 010-054-00
- Q&A: Availability of The Peterson Piranha LED Clearance or Side Marker Light In Amber M170A and Red M170R
- Q&A: Can Peterson Rectangular Clearance Light # M170A Replace Square Clearance Light on Trailer
on Trailer Lights
