One Rear Trailer Tire is Wearing Out on Tandem Axle Trailer  

There could be a couple of reasons for this. 1. The brake assembly in that position could be adjusted too tightly causing it to drag going down the road you can use the Brake Adjustment Spoon for Drum Brakes part #W80630 to loosen it up and test it…

It looks like the center of the tire has worn faster than the outer edges which is a tell tale sign that it has been overinflated or it is a different load range than the rest. If the leaf spring was worn more so for that particular side of the…

If you're backing into tight spots where the trailer is almost jackknifed, the best thing to do would be to remove the spring bars from your weight distribution system before backing. Everything should work fine at that point. The #HR26 extender…

We have a folding trailer tongue hinge that could work for the purpose you describe, as long as your trailer frame isn't constructed of aluminum. You could use the Fulton Fold Away Coupler Hinge, part #FHDPW330300. The hinge kit is designed for 3…

There are a number of issues that can cause irregular tire wear but generally this would be the tire wearing more on one side, not necessarily that the entire tire has worn faster than the others. If the latter is true then this could be an issue…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…