WirelessONE Remote Replacement for First Gen Kit

Question

Question:

Does this remote pair up with the first gen wireless one manifold?

asked by: Cody G

0

Expert Reply:

For the first generation WirelessONE the correct remote is the part # AL72704.

expert reply by: Jameson C

0

Answer 1

We have the right replacement remote for you, but for the first gen wireless manifolds it is a different part than the one you mentioned; what you need is the following: - Replacement Remote for Air Lift WirelessONE Compressor System for Air Helper…

view full answer...

Answer 2

No. If you don't have a remote to an AirLift WirelessONE system #AL25980EZ you can control this with the WirelessONE app on your phone or you can replace the compressor or you can get the part number off the manifold of the system to determine…

view full answer...

Answer 3

Yes, for just the replacement controller for the Air Lift WirelessAIR Compressor System for Air Helper Springs #AL74000 that you referenced you would want the #AL73002.

view full answer...

Answer 4

I found the remote that you will need for your Air Lift system. However, the #AL72704 that you referenced is the replacement remote for the WirelessOne system and not compatible. The replacement remote for the Air Lift WirelessAir Compressor System…

view full answer...

Answer 5

It sounds like you're looking for the 72704 replacement remote for an Air Lift system, which can be found with the Replacement Remote for Air Lift WirelessONE Compressor System for Air Helper Springs #AL72704.

view full answer...

Answer 6

The instructions you viewed for syncing the Replacement Remote for Air Lift WirelessONE, part #AL72704, were thus: 1. Turn ignition on. 2. Locate the sync wire in the wire harness.It will be the yellow wire that is looped with a yellow cap around it.…

view full answer...

Answer 7

I can just tell you the functions of remote #AL72704. The single dot is memory 1 and the 2 dots is memory 2. The up arrow increases air pressure and the down arrow decreases pressure. To save to memory press and hold one of the memory buttons for 5…

view full answer...

Answer 8

I am sorry to hear about that the remote for your Air Lift WirelessAIR Compressor System for Air Helper Springs - Remote - Bluetooth - EZ Mount #AL74000EZ isn't working properly! To set up the compressor to work with your smartphone you will need…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

WirelessONE Remote Replacement for First Gen Kit

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching