bing tracking image
Q & A Icon

Functions of the Buttons on Replacement Remote for Air Lift WirelessONE Compressor System  

Question:

If I order a new remote control, will it come with instructions on what the buttons are for.

0

Expert Reply:

I can just tell you the functions of remote # AL72704. The single dot is memory 1 and the 2 dots is memory 2. The up arrow increases air pressure and the down arrow decreases pressure.

To save to memory press and hold one of the memory buttons for 5 seconds.

To sync the remote use the following steps:

1. Turn ignition on.
2. Locate the sync wire in the wire harness. It will be the yellow wire that is looped with a yellow cap around it.
3. Remove the yellow wire from the cap leaving the cap attached to the harness.
4. Disconnect power to the receiver. Unplug the connector on the top.
5. Connect power to the receiver while grounding the sync input.
6. Listen for 3 clicks of the internal solenoid, then one click every second. This will indicate that you are now in the “sync mode”. Sync mode will last for 30 seconds total. Within the 30 seconds press any button on the transmitter to send a message to the receiver. Once the receiver has received a message it will sync with that transmitter and stop clicking the solenoid in 1 second intervals.
7. Reinsert the yellow wire terminal into the molded cap.

expert reply by:
0
Michael H

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>