Recommended Roof Vent Cover for a Ventline V3092-603-00

Question

Question:

Looking for recommendations for covers for our camper roof vents so we can leave our vents open - Ventline E-Z Lift Ventadome Trailer Roof Vent - Manual Lift and fan model in the bathroom - 14-1/4inch x 14-1/4inch - Smoke. Will the Camco roof vent cover work?

asked by: Luke A

0

Expert Reply:

The Camco RV and Enclosed Trailer Roof Vent Cover w/ Detachable Louvered Screen # CAM40431 will fit a Ventline E-Z Lift Ventadome Trailer Roof Vent # V3092-603-00. I do have to mention that the # V3092-603-00 will be 9 1/2 tall, and the # CAM40431 is also 9 1/2 inches tall, so there will be some contact when opened all the way. However, this will not affect or damage either product.

expert reply by: Lazer S

0

Answer 1

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink butt…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Thanks for the pictures of your roof vent lid Marty! Based on that the correct replacement is the Ventline part #BVD0449-A01 that you referenced if you wanted white or the part #BVD0449-A03 for the same smoke color you have now.

view full answer...

Answer 6

We do have the panels separately. What you're looking for is the Go Power Overlander Expansion Kit - 200 Watt Solar Panel #34282182.

view full answer...

Answer 7

A factory 7-way trailer connector isn't all you need to power a trailer's electric brakes. You still need a brake controller. Some Ford F-150s are equipped with a factory integrated brake controller, which you may have. If your 2012 Ford…

view full answer...

Answer 8

You're correct. The repalcement for your existing B12EA-22 brake would be #AKEBRK-7R-SA for the right side and #AKEBRK-7L-SA for the left.

view full answer...

Answer 9

To keep your back end from squatting, I recommend the Coil SumoSprings Custom Helper Springs for Coil Spring Suspension item #CSS-1094R. These insert into your rear springs and keep your suspension from being pushed down by the weight of your…

view full answer...