Are Bracket Heights The Distance From Mounting Plate to Foot on Lippert Power Stance Trailer Jack

Question

Question:

Are the bracket height measurements the distance from the mounting plate to the foot?

asked by: Alan W

0

Expert Reply:

That's a good question and yes, the bracket heights referenced does mean the distance from the mounting plate to the foot when retracted and extended for the jack you referenced, which is the following part:

- Lippert Power Stance Electric Trailer Jack # LC89VR

So when this jack is fully retracted, the distance from the bracket to the foot is 10-3/4 inches, and when the foot is all the way extended, the distance is 28-3/4 inches. The Power Stance is a really nice choice for an A-frame jack because of easy it is to use with a cord that allows you to simply plug it into your 7-way, which is much simpler than having to wire a jack to a battery.

I have added a link below to a video review for you to check out as well of the Lippert Power Stance Electric Trailer Jack # LC89VR.

expert reply by: Kyle S

0

Answer 1

I contacted the manufacturer for you and was able to get the dimensions of the Lippert jack: - Lippert Power Stance Electric Trailer Jack with 7-Way Plug #LC89VR. Overall it measures approximately 32-1/4 inches, with a 5-1/2 inch diameter footplate,…

view full answer...

Answer 2

To determine if this powered drive trailer jack will fit on your existing trailer and current set up you will need to measure from the center of the current mounting jack rearward. The Bulldog powered drive trailer jack that you referenced needs at…

view full answer...

Answer 3

I had our warehouse measure the Bulldog Powered Drive Trailer Jack - Drop Leg - A-Frame - 22" Lift - 4,000 lbs - White #BD500200 and it measures at 4-1/4" wide as shown in the included diagram. I included a video of the #BD500200 for you to…

view full answer...

Answer 4

The distance from the top of the mounting plate to the bottom of the housing on the Bulldog Powered-Drive Trailer Jack, #BD500200, is 13 inches.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The leg on your Atwood Power Jack AT80718 is not replaceable and since this jack is now discontinued by the manufacturer, the only solution is to replace it with a new jack. For a comparable jack, my expert recommendation is the Bulldog Powered-Drive…

view full answer...

Answer 7

The Electric Jack w/ Footplate and 7-Way Plug #EJ-3527-BBX has a 7-way for powering the jack and was designed to plug into your vehicle 7-way when needed to raise and lower and then when you go to tow you'd plug your trailer 7-way back in. We…

view full answer...

Answer 8

The Electric Jack w/ Footplate and 7-Way Plug #EJ-3527-BBX that you referenced has a height of 20-1/2 inches from where it mounts to your trailer frame to the top of the jack.

view full answer...

Answer 9

The Lippert Power Stance Electric Trailer Jack with Footplate #LC89VR will fit your 2023 Coachmen Apex Nano 194BHS. It actually fits any trailer with an A-frame and the standard jack bolt pattern so it is pretty universal.

view full answer...