Kwikee Step Controller Replacement for Module # 1510000140

Question

Question:

Looking for a replacement module #1510000140. Is the LC381020 the correct controller replacement?

asked by: Jeff

0

Expert Reply:

I checked with Lippert and the part number you have of 1510000140 corresponds with the Revolution Kwikee step and the replacement control module you need then is the part # LC363985.

expert reply by: Jameson C

0

Answer 1

I checked with Lippert and the part number you have of 1510000140 corresponds with the Revolution Kwikee step and the replacement control module you need then is the part #LC363985. Based on what you described it sounds like the module is bad and…

view full answer...

Answer 2

The replacement module for 40 series Kwikee RV steps #LC363985 is for a new module and is the correct part for your 40 series steps that were made in 1999.

view full answer...

Answer 3

The purple wire from the Lippert Components Kwikee Revolution Step Control Module #LC363980 is actually an optional wire that can be connected to a porch light so the light goes on whenever the steps are extended. The wire does not need to be…

view full answer...

Answer 4

It looks like the 1510000172 part number is for the control boxes on the Revolution Series steps. We have that here. While the #LC379146 that you referenced does look similar, this is not the correct one. The correct one for you is part #LC363980.…

view full answer...

Answer 5

Your Kwikee 1510000140 needs to be replaced with the Control Unit #LC363985. You cannot replace it with the Kwikee 9510 Controller #LC379146.

view full answer...

Answer 6

In order to test the motor on what I assume are set of Lippert Kwikee Electric Steps, you will first want to sever the yellow and red wires on the motor. Once you do this you will then need to obtain access to a 12 volt power source you know…

view full answer...

Answer 7

It sounds like you're trying to replace the motor on your Kwikee steps with the part number 366043, and we have just what you're looking for. In order to replace the motor for these steps you'll want to use the Replacement Motor for…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Kwikee Step Controller Replacement for Module # 1510000140

Product Page this Question was Asked From

Continue Researching