Will the Timbren TGMRCK25D Fit a 2018 Silverado 3500 4 Wheel Drive?

Question

Question:

I have a 2018 Chevrolet Silverado 3500HD 4WD standard bed with factory installed puck system for my fifth wheel hitch. I just want to confirm the Timbren suspension enhancement part TGMRCK25D is the correct part. Thanks

asked by: Gary A

0

Expert Reply:

The Timbren # TGMRCK25D will definitely fit your 2018 Chevy Silverado 3500 4 wheel drive. This is also compatible with the factory puck systems as well as with or without factory top overload springs.

expert reply by: Lazer S

0

Answer 1

The B&W Companion #BWRVK3500 being a single point attachment cannot be used with your Lippert Turning Point or another pin box which changes the pivot point. You can use the B&W Companion Slider #BWRVK3400 which will gain you 12" of…

view full answer...

Answer 2

You can use the rear hitch receiver on your 2020 Forest River Rockwood MiniLite. For your specific bikes, I recommend the Swagman Platform-Style 2 Bike Rack for 2" Hitches or RV Bumpers #S64663 which is rated for travel trailer use as long as…

view full answer...

Answer 3

The difference between the Timbren Jounce Springs #TGMRCK25D and #TGMRTT35D for your 2019 Chevy Silverado 2500 is that the former is for standard pickup truck use while the latter is for Severe Service vehicles only. Since it doesn't sound like…

view full answer...

Answer 4

Yes, the Timbren kit part #TGMRCK25D that you referenced will fit your 2016 Chevy Silverado 2500HD that has 20 inch rims. Nice looking truck! I attached an install video as well.

view full answer...

Answer 5

The Timbren Rear Suspension Enhancement System part #TGMRCK25D which is a fit for a 2018 GMC Sierra 2500 will measure 5-1/4" tall without the 1" spacer or 6-1/4" tall with the 1" spacer. I have attached a photo below. The springs…

view full answer...

Answer 6

The Timbren Rear Suspension Enhancement system that you referenced #TGMRCK25D, is intended to replace the factory installed bump stops on your truck. These Timbrens are confirmed as a fit for a 2012 Chevy Silverado Pickup 2500 or 3500 and fit both…

view full answer...

Answer 7

The Timbren Rear Suspension Enhancement System #TGMRCK25D you were looking at for your 2013 Chevrolet Silverado 2500HD 4x4 are 5-1/4" tall without the 1" spacer, or 6-1/4" tall with it. You want 1" - 1-1/2" gap between the…

view full answer...

Answer 8

To better support the weight of your Arctic Fox 865 Camper I highly recommend the Timbren Rear Suspension Enhancement System #TGMRCK25D. These heavy-duty Aeon hollow rubber springs will greatly increase stability on the road with that camper…

view full answer...

Answer 9

The biggest difference between the two parts is that the Timbren Rear Suspension Enhancement System #TGMRCK25D is a double-convoluted spring while the Timbren Rear Suspension Enhancement System #TGMRTT35D are single-convoluted springs. The…

view full answer...

Answer 10

To help suspend payload carried in the truck's bed, I'd recommend using #TGMRCK25D, which are rated up to 8600 lbs. Keep in mind, these will NOT increase the manufacturer's stated suspension capacity. For a slide-in camper or salt…

view full answer...

Answer 11

Congratulations on your new truck bed camper! I'm sure you will enjoy it for many years. Sway is a common issue with truck bed campers which can be reduced, but not eliminated. The campers are not particularly aerodynamic and the sway will…

view full answer...

Answer 12

Sounds like you are looking for a anti-sway bar which will minimize sway and driver fatigue by improving the stability and drivability of your vehicle. The bar on this sturdy, effective anti-sway system mounts to the rear axle and to the frame to…

view full answer...