Replacement Strut for Solera Power Awning

Question

Question:

Need a part! The shock seems weak!

asked by: Shannon

0

Expert Reply:

Sounds like you are looking for a replacement strut for your Solera awning which would be the part # LC280343.

expert reply by: Jameson C

0

Answer 1

To order the correct Solera replacement arm size, simply measure the length of the wall-mount extrusion from top to bottom. I've pointed this out using the photo you sent in as an example. Short styles will measure 61-1/2" and use part…

view full answer...

Answer 2

The awning arms are measured from top to bottom of the wall mount. This can then be used to select the correct length replacement. I have attached a photo below to assist. You will also need to pay attention to the style of arms such as pitched or…

view full answer...

Answer 3

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 4

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 5

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 6

Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch studs and…

view full answer...

Answer 7

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 8

Typically, when the outside edges of a tire are showing wear its because the tires are under-inflated. The solution is to inflate the tires to the maximum pressure listed on the sidewall. Now if the outside of tires have what looks like gouges are…

view full answer...

Answer 9

Surge brakes use a hydraulic actuator to push fluid to the cylinder piston to activate the brake shoes on drum brakes or brake pads on disc brakes. This pressure should only be applied when weight is pushing against the hitch ball, so no pressure…

view full answer...

Answer 10

The Blue Ox systems cannot be moved back that far but we do have the perfect system for you. Take a look at the Reese SC weight distribution systems linked to the right (minus the ones that say Light Duty). These systems have narrow brackets that can…

view full answer...

Answer 11

You can get a new brake mounting flange for your axle. The old flange will need to be cut off. The part is #4-44-1. This is designed to fit a 3 inch trailer axle and should be welded in place by a professional. Since you would also have to get the…

view full answer...

Answer 12

We do have 205/75R14 size radial tires that have a load range of D and a speed rating of at least 81 mph. Out of our available selection I recommend going with the Kenda Karrier #AM10235. This tire has a max load rating of 2,200 lbs at 75 psi and a…

view full answer...

Replacement Strut for Solera Power Awning

Products Referenced in This Question

Featured Help Information

Instructions

Continue Researching