Replacement Grease Seal for P10495TB

Question

Question:

The following is on the grease seal: TGS P10495TB 2.125 3.371 0.313 Do you have them?

asked by: Wayne M

0

Expert Reply:

Yes, we do have the grease seal you're after. It's the 10-10 Grease or Oil Double-Lip Seals part # RG06-090.

expert reply by: Conner L

0

Answer 1

We can help you find a replacement hub for your trailer but we don't have a way to look up the serial number you listed. In order to pick out the correct hub assembly for a trailer you are going to need know a few key pieces of information.…

view full answer...

Answer 2

We sure can! The Transcom #TCM 21344 TB cross references to the 10-10 seal we offer, part #RG06-090. The seal has a 2.125 inch ID and a 3.376 OD. It's compatible with a 25580 inner bearing.

view full answer...

Answer 3

The side plates of the B&W gooseneck trailer hitch #BWGNRK1313 will mount on the outside of each frame rail of your 2004 Dodge 2500 8-foot bed. See the B&W video I included at the 7 min and 30 second mark. If your Firestone air bags…

view full answer...

Answer 4

You can verify that the 10-19 grease seal included in Bearing Kit #BK2-100 is the correct one for your spindles by taking two measurements. First you want to measure the rear hub bore where the seal is inserted. The seal's outer diameter…

view full answer...

Answer 5

According to my research the Transcom part 21334TC is an oil seal with a 2.125" inner diameter and a 3.372" outer diameter and the Transcom part 2133TB is a grease seal with a 2.125" inner diameter and a 3.376"…

view full answer...

Answer 6

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 7

The majority of 5,200 lb to 7,000 lb trailer axles use a grease/dust cap with a 2.72" inner diameter in which case you could use part #TRDC-275 or part #K7CAP if you have zerk fittings on the spindle. That said, it is always best to measure…

view full answer...

Answer 8

It took a bit of cross-referencing, but I found that the 10-10 grease seal, part #RG06-090 is the correct replacement for the Al-KO 568862 seals. You can confirm this by checking the ID of the hub bore where the seal would sit. The ID should be…

view full answer...

Answer 9

Yes, the RG06-090 replaces the National 470972. On the product page we have a link to the cross-reference for the National part number.

view full answer...

Answer 10

According to our FAQ on slipper springs, linked for referenced, the torque specs are as follows: Torque Ratings 1/2 inch Bolts: 45 ft/lbs - 70 ft/lbs 9/16 inch Bolts: 65 ft/lbs - 95 ft/lbs 5/8 inch Bolts: 100 ft/lbs - 120 ft/lbs The Replacement…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Replacement Grease Seal for P10495TB

Product Page this Question was Asked From

Continue Researching