Does Replacement Top Cover for Lippert Electric Trailer Jack # LC285160 Come with Switches

Question

Question:

Hello there E trailer question would this part replace all these items that I found on Lipperts part list for my damaged jack. 1. 1 285160 2. 1 225876 3. 1 226018 4. 1 226023

asked by: Ryan

0

Expert Reply:

Yes the Replacement Top Cover for Lippert Electric Trailer Jack # LC285160 does come with all of the switches like what you mentioned.

expert reply by: Jameson C

0

Answer 1

When it comes to checking your retract/extend functions not working it sounds like you may just need to swap some wiring on the back. I will attach picture of the wire swaps. It sounds funny but per the manfuacturer that does seem to help. If that…

view full answer...

Answer 2

For the replacement top cover for your Lippert Electric Trailer Jack #LC285318 you will use the part #LC285160. This is the top plastic black cover that comes down over the switches. The protective lens for this jack is no longer available as a…

view full answer...

Answer 3

Yes, I confirmed with Lippert that the Replacement Top Cover for Lippert Components Electric Trailer Jack part #LC285160 will fit your Lippert 3,500 Lb Electric tongue Jack 1817941.

view full answer...

Answer 4

Lippert does not offer a replacement inner jack tube for their jack 1817941. When a jack is damaged in this way (which is more common than you want to know) it really is best to replace the entire jack for safety reasons. The outer tube on your jack…

view full answer...

Answer 5

I spoke to my contact at Lippert about wiring the toggle switches for the Lippert Electric Trailer Jack #LC285318. They stated that they don't have any schematics on this unfortunately but what we were able to do is snap a photo of the back of…

view full answer...

Answer 6

For a Lippert jack model 181794 a replacement manual crank nut is not available. I checked with my contact at Lippert to confirm. You will need to replace your jack with a complete new one, I am sorry to say. To help you select a new one I have…

view full answer...

Answer 7

I do have an option for you, however there is not a replacement motor available for your Lippert model 1817941 Electric A-Frame Trailer Jack. I recommend simply replacing the jack itself with the Lippert Electric Trailer Jack #LC285318, which is what…

view full answer...

Answer 8

The Atwood 87701-SP three-switch panel that you referred to is now obsolete, no longer made, and none in stock. The only wiring information I could find for you is a poor quality drawing from Atwood/Lippert which I have attached. We do not have this…

view full answer...

Answer 9

You can use the Replacement Tongue Jack for Lippert Ground Control TT Leveling System #LC421366 as a jack and it sounds like you might be testing the function without it attached to the trailer, which is why it's not working. This unit does not…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...