Will the Bully Black Bull Side Steps Fit My 1995 Ford F-250?

Question

Question:

noted that fit for 1995 F250 pick up NOT CONFIRMED. Does that mean it will not fit this vehicle or you have no confirmation from feedback?..... or does it not have correct brackets?

asked by: Eric L

0

Expert Reply:

I have a solution for you. When the Bully Black Bull Adjustable Side Steps - Aluminum w/ Matte Black Powder Coat - 9" Step - 1 Pair # BBS-1101S-2 says "Not Confirmed," it means that either the dimensions of the step or the hardware that mounts the step are not compatible with your 1995 Ford F-250. Sometimes, on newer models within 1 or 2 years of production, the "Not Confirmed" status could mean that we have not yet tested it on a certain model. However, with your 1995 Ford F-250, we have tested the Bully Black Bull Side Steps on your vehicle and it would not fit.

However, if you are looking for a black pair of side steps that will fit your vehicle, I recommend the Carr Custom-Fit Side Steps - Hoop II - Black Powder Coated Aluminum - 7" Step - 1 Pair # CARR102521. The XP3 Xtreme black powder coat on the Carr steps resists chipping, peeling and fading. Also, it is the more economic option when compared with the Bully Black Bull steps. The Carr Steps comes with all mounting hardware needed for installation on your vehicle.

expert reply by: Bob C

0

Answer 1

You have come to the right place to find side steps for your 1994 Ford F-350 with a 6" lift and I highly recommend the Carr Custom-Fit Side Steps because they offer you the best footing with their tread pattern and have a significant drop to…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hey Mark, so the correct Blue Ox base plate kit to use with the Blue Ox Ascent tow bar part #BX4375. is the part #BLU53FR. For lighting you can use #C96JR, and not have to worry about cutting into the taillight housing as this plugs inline with the…

view full answer...

Answer 5

I did some looking and found that the 46210 and 46845 hubs you currently have use the same #L68149 inner bearing and #L44649 outer bearing. However, as we do not carry the Tie Down Engineering Vortex hubs, I cannot say what all will fit them,…

view full answer...

Answer 6

The Dexter 8-427 hub is no longer available. Even looking through Dexter's site the only references to it are replacement bearings. You can use a wheel with a larger pilot hole as long as the wheel attaches to the hub using lug nuts and not…

view full answer...