Tire Changing on Triple Axle with Blaylock EZ Jack and Wheel Chock

Question

Question:

Would this work on a tri axle trailer ?

asked by: TOM D

1

Helpful Expert Reply:

Per contact at # EZ-Jack, they state that to use the # EZ-Jack on a triple axle trailer you will need to turn the curve up, opposite the wheel, and drive up on the jack and you will be able to change the tires.

expert reply by: Michael R

1

Answer 1

Yes, the Blaylock EZ Jack and Wheel Chock part #EZ-JACK can be used on a triple axle trailer like you have but you would need to turn the curve up, opposite the wheel, and drive up on the jack and you will be able to change the tires. Otherwise the…

view full answer...

Answer 2

I spoke with my contact at EZ-Jack and he says that to use the EZ-Jack on a triple axle trailer you will need to turn the curve up, opposite the wheel, and drive up on the jack and you will be able to change the tires. Other wise a floor jack and…

view full answer...

Answer 3

The Blaylock EZ Jack and Wheel Chock for Tandem-Axle Trailers #EZ-JACK is not rated for use on triple axle trailers. We do not currently carry a drive-on wheel jack for triple axle trailers so you would instead need to use a standard bottle jack like…

view full answer...

Answer 4

If you need to replace just one tire or do other work on one axle of a tandem axle trailer on just one side of the trailer then yes, you would need just one of the EZ Jacks, #EZ-JACK. But if you want both sides of the axle to be off the ground you…

view full answer...

Answer 5

I have a solution for you, but the #EZ-JACK won't work well on a triple axle trailer. It would be too difficult to get the jack between the tires of a triple axle trailer and the height wouldn't be enough. Take a look at the Ultra-Fab…

view full answer...

Answer 6

Yes, the Blaylock EZ Jack and Wheel Chock part #EZ-JACK that you referenced will work with torsion axle trailers like what you have on your trailer. It works just as well with torsion axles as it does with leaf spring axles. I attached a review video…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Hey Joe, yes the Lippert stabilizer jack part #LC298707 does fit your Grand Design Transcend 245RL but it is sold individually so if you wanted a set for the front and the rear you would need to order a quantity of two.

view full answer...