Recommended RoadActive Suspension for a 2015 GMC 2500

Question

Question:

I want to make sure I am ordering the right part for my truck. 2015 GMC Sierra 2500 with overload springs on the bottom thank you

asked by: Tracy W

0

Expert Reply:

With your 2015 GMC Sierra 2500 not having the overload springs on the top, the RoadActive Suspension # RAS3611-HD will be the correct ones for you.

expert reply by: Lazer S

0

Answer 1

The 2,000 pound standard RAS for your 2017 Silverado 2500, part #RAS3611, is going to be enough to help you tow your 13,000 pound Keystone. If you're only towing the trailer a few times a year this is the route I would go. If you're…

view full answer...

Answer 2

We can get your 2021 GMC Sierra 3500 with a single rear wheel set up with an outstanding suspension enhancement option that will help your truck's sag, improve it's handling, won't negatively affect your unloaded ride, is…

view full answer...

Answer 3

You'd want to look at the springs of your 2016 GMC Sierra 2500HD to determine if it has overload springs (most likely it does). If the spring pack has what looks like a smaller spring attached to the bottom of the spring pack that is flatter…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 6

Beds shorter than 8 foot do commonly need a slider hitch David, but a lot of modern fifth wheel trailers are now made with tapered noses to help and in a lot of cases a slider isn't required. So if the trailer you plan to tow has a tapered nose…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

Great question, Jeff! When the Rota-Flex first came out it renovated what a pin box could do and be, but at this point in time that technology is a little more dated and the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is the "new…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…

view full answer...

Recommended RoadActive Suspension for a 2015 GMC 2500

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching