What Is The Bolt Pattern Of The Brake Mounting Bolts On Dexter Brake Kit 23-398-399?
Question:
bolt distance center to center 4. i didnt see or over looked. and can i use my attwood hubs, like new. I.D. of hub is 6.810, will your system close up enough for it to fit. thank you
asked by: Perry
Helpful Expert Reply:
The 4 mounting bolts on the Dexter Hydraulic Trailer Brake Kit - Uni-Servo - 7" - Left and Right Hand Assemblies - 2.5K # 23-398-399 you were looking at are 2-3/4" apart on center or 4" apart when measured diagonally and will fit your brake mounting flange where the holes are 4" apart on center.
Now I have not heard of an Atwood hub that has an I.D. of 6.810". Would you happen to be able to send me the part number on the hub so I can cross reference it and confirm which brakes it works with?
I included a video of the # 23-398-399 for you to take a look at.
Product Page this Question was Asked From
Dexter Hydraulic Trailer Brake Kit - Uni-Servo - 7" - Left and Right Hand Assemblies - 2.5K
- Trailer Brakes
- Hydraulic Drum Brakes
- Standard Grade
- Manual Adjust
- Single Servo
- 7 x 1-3/4 Inch Drum
- 2500 lbs Axle
- 10 Inch Wheel
- 12 Inch Wheel
- 13 Inch Wheel
- Dexter
more information >
Continue Researching
- Shop: Dexter Hydraulic Trailer Brake Kit - Uni-Servo - 7" - Left and Right Hand Assemblies - 2.5K
- Video: Dexter Axle Trailer Brakes - Hydraulic Drum Brakes - 23-398-399 Review
- Q&A: Can Replacement Parts Still Be Had for Atwood Hydraulic Braking Assemblies 84210
- Shop: Uni-Servo Wheel Cylinder Assembly for 7" Brake Assemblies - Driver-Side
- Shop: Trailer Hub and Drum Assembly - 2K Axles - 7" Diameter - 5 on 4-1/2 - L44643 - Pre-Greased
- Q&A: Replacement Actuator For An Atwood 171
- Shop: Uni-Servo Wheel Cylinder for 10", 12" and 13" Dexter Brake Assemblies - Zinc - LH
- Q&A: Can Studs be Installed and Used Instead of Bolts for Trailer Hubs/Wheels
- Shop: Dexter Hydraulic Drum Brake Assembly - Uni-Servo - 7" - Right Hand - 2,500 lbs
- Shop: Dexter Electric Trailer Brakes - 7" - Left/Right Hand Assemblies - 2,000 lbs to 2,200 lbs
- Q&A: Correct Replacement for Atwood 7" x 1-3/4" Hydraulic Drum Brakes
- Search Results: wheel cylinders
- Shop: Dexter Hydraulic Drum Brake Assembly - Uni-Servo - 7" - Left Hand - 2,500 lbs
- Search Results: dico wheel cylinder
- Search Results: surge brake master cylinder
- Search Results: surge brake coupler
- Search Results: wheel cylinder
- Search Results: 84132
- Video: Kenda Tires and Wheels - Tire with Wheel - AM3H480 Review
- Video: Titan Brake Assemblies Uni-Servo Wheel Cylinder Installation
- Q&A: Replacement Surge Brake Actuator for Atwood 82543
- Video: TruRyde Trailer Bearings Races Seals Caps - Seals - RG06-020 Review
- Video: Review of TruRyde Trailer Bearings Races Seals Caps - Seals - 10-9
- Video: Bearing Repacking and Grease Seals Installation
- Q&A: Replacement Seal to Replace National Oil Seal Part # 474276
- Q&A: Best Replacement for Atwood 82543 Brake Actuator
- Video: Dexter Electric Trailer Brake Kit Installation
- Search Results: 7" electric brakes