Cap Diameter of Maxxtow Lock # MT66FR

Question

Question:

Hello, I understand the lock pin is 1/4inch diameter, but what is the diameter of the pin cap non-locking end? It looks like it could be 3/4???

asked by: Steven P

0

Expert Reply:

The lock end of the MaxxTow # MT66FR measures .875 which is 7/8 inches in fraction form.

expert reply by: Jameson C

0

Answer 1

A 235/75-15 tire like what you have would measure right at 29 inches in diameter. So for that we have the CE Smith cover part #CE27440 which would fit and work well for an all black cover. I also attached a link to a page that has all of the spare…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hi Bruce, To lift your trailer we'll first need to check of the suspension and see if you have torsion axles or a leaf spring suspension. If you have torsion axles then I'll need to see the axle tag in order to determine what you have so I…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

One option is to relocate the propane tank tray. A lot of times the trays are attached to the A-frame with self tapping screws. You could remove the screws and move the tray front/back as needed. There is not any kind of adapter that is made for this…

view full answer...

Answer 8

When it comes to The Fastway Trailer Hitch Receiver Lock - 2 inch Hitches - 5/8 inch Diameter - Qty 1 #FA86-00-3050 can be keyed alike. You would have to purchase the receiver lock first then when you receive the part get the key number. Then you…

view full answer...

Answer 9

The Blue Ox #BXW1500 Weight Distribution Hitch utilizes clamp-on brackets to tighten the chains at, but as it turns out will not work with larger 8" frames. You will need to use the Blue Ox #BLU98FR Lift Brackets for 8 inch frames. I reached out…

view full answer...

Answer 10

Yes the Clamp-On Lift Brackets for Blue Ox SwayPro Weight Distribution Systems #BXW4010 that you referenced do fit boxed trailer frames.

view full answer...

Answer 11

I don't have the length of the spring bar arms on the Blue Ox 2-Point Weight Distribution System like part #BLU75FR but I can tell you that the frame brackets will need to be installed between 25-27" back on the frame from the center of the…

view full answer...

Answer 12

This is a pretty common issue with aluminum frames so we definitely have a options available for you. With that being said, the 8 inch frame height will make things a bit more difficult, but not impossible. First, the Curt TruTrack Weight…

view full answer...

Cap Diameter of Maxxtow Lock # MT66FR

Product Page this Question was Asked From

Continue Researching