Dimensions of Replacement Bail Clamp # F2135823353

Question

Question:

WHAT IS THE DEEP AND WIDE?

asked by: JAIBONG K

0

Expert Reply:

We went out and measured the # F2135823353 and the inside depth is 3-1/8 inches and the outer depth is 3-3/8 inches. The end of the threading is a little uneven considering the cut from the manufacturer so the depths may vary between each u-bolt.

Outside width is 4 inches and the inside width is 3-5/8 inches.

expert reply by: Jameson C

0

Answer 1

I went out to our warehouse to take a look at all of the Replacement Bail Clamps we currently have available for the Firestone Ride-Rite Air Helper Springs. For both the Replacement Bail Clamp #F3373 and #F3077, there is a distance between threaded…

view full answer...

Answer 2

You can wire the Hopkins 7 Way Molded Trailer Plug #HM20048 in whichever manner you see fit- the colored wires in the loom are color coded to make it easy for you to know which pin/blade they&#39;re connected to, so you shouldn&#39;t…

view full answer...

Answer 3

I went out to the warehouse and pulled Replacement Lower Bracket for Firestone Ride-Rite air bags #F5092 to take some measurements. The overall length is 11-3/8 inches, overall width is 5 inches, and overall height is 2-1/4 inches. I took many…

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn&#39;t fit their factory 7-way as well. I&#39;ve attached an article to help if you have one of the 7-way or 6-way round…

view full answer...

Answer 5

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the…

view full answer...

Answer 6

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory…

view full answer...

Answer 7

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 9

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Dimensions of Replacement Bail Clamp # F2135823353

Product Page this Question was Asked From

Continue Researching