CAMCO Drain Trap For 3/4" Drain Hose Dimensions

Question

Question:

Is the 3/4inch hose for the CAM 37262 Drain Trap a 3/4inch inside diameter hose or 3/4inch outside diameter hose?

asked by: Glen

0

Expert Reply:

The inside diameter is 3/4" for the # CAM37262. The hose will expand with some pressure up over the ribs and a hose clamp will tightly secure the hose onto the drain trap.

expert reply by: Kevin C

0

Answer 1

The Camco RV Drain Trap #CAM37262 will work fine with the 2" hole in your shower pan. I was not able to find any specs or references for this "tv shower pan" you mentioned, but if the drain hole is 2" it should work fine. It is…

view full answer...

Answer 2

The custom fit VanRug made for your 2015 Sprinter 2500 with 144in wheelbase is VanRug Custom Floor Mat for Cargo Vans - Charcoal Gray - Carpet #VRMS06M. It is designed for the cargo Sprinter Van and extends from behind front seats to under cargo…

view full answer...

Answer 3

We do have VanTred mats that fit your 2020 Ram Promaster City with the part #VTDCP14 for black or #VRDPC14 for gray. This does fit the ribbing in the floor of the Promaster city. We do not have covers for the wheel wells though.

view full answer...

Answer 4

The overall height of the Camco RV Sink Trap part #CAM37262 is 3-3/4 inches.

view full answer...

Answer 5

The MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat part #MA00-06200K has a max amp draw rating of 9 amps on startup. It's best to run a wire straight to the battery so you can ensure the correct gauge is used based on the amp draw and length…

view full answer...

Answer 6

Per the manufacturer, Excel, the Excel RV Tankless On-Demand Water Heater - Gas - Electric Ignition - 38,000 Btu #EX93FR has to be installed upright with the vent facing upwards. Other than that the only other installation restriction is to not…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 9

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 10

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

CAMCO Drain Trap For 3/4" Drain Hose Dimensions

Product Page this Question was Asked From

Continue Researching