Can I Add a Trailer Strobe Light to My Gooseneck Trailer

Question

Question:

How do I connect a strobe light on a gooseneck trailer And what parts do I need

asked by: TIMOTHY

0

Expert Reply:

You don't need to make any special connections- you'll just power it through whichever circuit you want it to function on. You could use a light like the LED Mini Strobe Light - Surface Mount - 19 Flash Patterns - Amber and White LEDs # 3378891132 on the back of your trailer as additional reverse lights. You won't need to use the # STR-QRLY since these are already strobe lights.

In addition to the strobe lights you'll want some 12 gauge wire # 12-1-1 (sold by the foot) and butt connectors like the # DW05745-10 to complete the lighting.

expert reply by: Erik B

0

Answer 1

According to the linked installation instructions, the pink wire you describe is for an optional feature that will allow the #AL74000 WirelessONE compressor system to make adjustments as soon as the ignition is turned on. Otherwise, the system will…

view full answer...

Answer 2

Thanks for the picture of what you have and the info you listed. The correct wheel you need is the part #AM20794 that you referenced.

view full answer...

Answer 3

Yes, the Furrion Automatic Transfer Switch #F30ATS has a wiring diagram on the inside of the cover. I've attached a picture of the diagram as well as a picture of the terminals with their functions.

view full answer...

Answer 4

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching…

view full answer...

Answer 5

Is the battery of the breakaway kit charged? Does your tow vehicle have a brake controller installed?

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 7

The first thing to do is disconnect the trailer from the Liberty. Then using a circuit tester, like part #PTW2993, test each pin of the 4-Way. Clip the alligator clip of the circuit tester to the exposed post, the ground wire. Check each pin with…

view full answer...

Can I Add a Trailer Strobe Light to My Gooseneck Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching